Using angle-resolved photoelectron spectroscopy and ab initio calculations, we unambiguously show that the widely investigated three-dimensional topological insulator BiSe has a direct band gap at the point. Experimentally, this is shown by a three-dimensional band mapping in large fractions of the Brillouin zone. Theoretically, we demonstrate that the valence-band maximum is located at the point only if many-body effects are included in the calculation. Otherwise, it is found in a high-symmetry mirror plane away from the zone center.
We present quasiparticle self-consistent calculations of semimetallic bulk Bi. We go beyond the conventional method by including the spin-orbit coupling throughout the self-consistency cycle. This approach improves the description of the electron and the hole pockets considerably with respect to standard density functional theory (DFT), leading to excellent agreement with experiment. We employ this relativistic approach to conduct a study of the semimetal-to-semiconductor and the trivial-to-topological transitions that Bi experiences under strain. DFT predicts that an unphysically large strain is needed for such transitions. We show, by means of the relativistic description of the electronic structure, that an in-plane tensile strain of only 0.3% and a compressive strain of 0.4% are sufficient to cause the semimetal-to-semiconductor and the trivial-to-topological phase transitions, respectively. Thus, the required strain moves into a regime that is likely to be realizable in experiment, which opens up the possibility to explore bulklike topological behavior of pure Bi.
Results of density-functional calculations for indium thiospinel semiconductors substituted at octahedral sites with isolated transition metals () show an isolated partially filled narrow band containing three -type states per atom inside the usual semiconductor band gap. Thanks to this electronic structure feature, these materials will allow the absorption of photons with energy below the band gap, in addition to the normal light absorption of a semiconductor. To our knowledge, we demonstrate for the first time the formation of an isolated intermediate electronic band structure through substitution at octahedral sites in a semiconductor, leading to an enhancement of the absorption coefficient in both infrared and visible ranges of the solar spectrum. This electronic structure feature could be applied for developing a new third-generation photovoltaic cell.
We present $GW$ calculations of the topological insulators Bi${}_{2}$Se${}_{3}$, Bi${}_{2}$Te${}_{3}$, and Sb${}_{2}$Te${}_{3}$ within the all-electron full-potential linearized augmented-plane-wave formalism. Quasiparticle effects produce significant qualitative changes in the band structures of these materials when compared to density functional theory (DFT), especially at the $$\Gamma${}$ point, where band inversion takes place. There, the widely used perturbative one-shot $GW$ approach can produce unphysical band dispersions, as the quasiparticle wave functions are forced to be identical to the noninteracting single-particle states. We show that a treatment beyond the perturbative approach, which incorporates the off-diagonal $GW$ matrix elements and thus enables many-body hybridization to be effective in the quasiparticle wave functions, is crucial in these cases to describe the characteristics of the band inversion around the $$\Gamma${}$ point in an appropriate way. In addition, this beyond one-shot $GW$ approach allows us to calculate the values of the ${Z}_{2}$ topological invariants and compare them with those previously obtained within DFT.
This first-principles study describes the properties of Si implanted with several chalcogen species (S, Se, Te) at doses considerably above the equilibrium solubility limit, especially when coimplanted with the group III atoms B and Al. The measurements of chalcogen-implanted Si show strong optical absorption in the infrared range. The calculations carried out show that substitution of Si by chalcogen atoms requires lower formation energy than the interstitial implantation. In the resulting electronic structure, at concentrations close to 0.5%, an impurity band determined by the properties of the chalcogens introduced is observed in the forbidden energy gap of Si. Although this band is a few tenths of an electron volt wide, it remains energetically isolated from both the valence and the conduction bands. Appropriate coimplantation with group III elements allows control over the occupation of the intermediate band while modifying its energies only slightly. A moderate energy gain (especially small for B) seems to be obtained when p-doping atoms occupy the sites next to those of the chalcogens. Therefore, the apparent electrostatic attraction between species that in isolation would act as acceptors and double donors is smaller than expected. The intermediate-band properties have been preserved for all of the coimplanted compounds analyzed here, regardless of the species involved or the distance between them, which constitutes an appreciable advantage for the design of new experimental materials.
With the intermediate band electronic structure, more efficient solar light harvesting in photocatalysis and photovoltaics becomes possible. Here V-substituted In2S3 is synthesized, being the first...