1 July 2018 in APL Materials
Aluminum scandium nitride (Al1−xScxN with x = 0–0.41) thin films were deposited by reactive pulsed-DC magnetron sputtering on Si(001) and Al2O3(0001) substrates. X-ray diffraction indicated high degree of c-axis orientation in all the films, and based on pole figure measurements, epitaxial relationship could be defined as AlScN// sapphire and (0001)AlScN//(0001)sapphire in films deposited on Al2O3. Piezoelectric coefficient increased up to d33 = 31.6 pC/N in Al0.59Sc0.41N, which is 550% higher than for AlN. The biaxial elastic modulus and the in-plane coefficient of thermal expansion (CTE) as a function of Sc concentration were determined by thermal cycling method: biaxial elastic modulus decreased from 535 GPa in pure AlN to 269 GPa in Al0.59Sc0.41N and CTE was 4.65 × 10−6 K−1 for AlN and 4.29 × 10−6 K−1 for Al0.59Sc0.41N. Additionally, we observed an increase in CTE from 4.18 × 10−6 K−1 at 65 °C to up to 6.38 × 10−6 K−1 at 375 °C for Al0.68Sc0.32N. The experimentally determined CTE and elastic modulus allow a more precise design of Al1−xScxN-based frequency filters which are used in mobile communications and are important parameters for the prediction of device performance at elevated temperatures.
13 November 2017 in Physica Status Solidi (a)
9 January 2014 in IEEE Journal of Photovoltaics
Besides passivation of the c-Si absorber, provided mainly by the undoped buffer layer, the net doping of the silicon thin films plays a major role in the performance of silicon-based heterojunction (SHJ) solar cells. However, junction engineering is complex as high net doping often interferes with the interface passivation and the optical properties of the silicon thin films. We show that injection-level-dependent open-circuit voltage (Suns- Voc) measurements are a simple and valuable method for the characterization and optimization of the doped amorphous silicon (a-Si:H) layers. It is shown by experiment and device simulations that at high illumination intensities the Suns- Voc characteristic exhibits a strong signature of defect recombination within the a-Si:H, which is determined by the a-Si:H doping and the interfacial transparent conducting oxide (TCO) properties. This fact is exploited for a qualitative interpretation of the interplay between a-Si:H and the interfacial TCO properties. As a clear correlation between the Suns- Voc characteristic and the maximum power point conditions of the devices exists, fill factor (FF) losses attributed to the doped a-Si:H and the interfacial TCO properties can 1) be easily predicted in the early stage of device optimization on simple test structures, or 2) these FF losses can be identified and distinguished from other FF losses in the final device.
1 June 2017 in Applied Surface Science
1 January 2013 in Energy Procedia
In this work we experimentally investigate the influence of the chemical and field effect passivation of a-Si:H films on the junction recombination at maximum power point conditions of silicon heterojunction solar cells. By simulating the charge of doped a-Si:H films with external corona charges, chemical and field effect passivation are investigated independent of each other. If we apply a negative corona charge to a lifetime test structure inversion conditions are obtained which corresponds to a p/n junction. With positive charges we can create accumulation i.e. a high/low junction (for an n-type wafer). From injection level dependent lifetime measurements the implied solar cell parameters iVoc and iFF are extracted. Especially the implied fill factor is influenced by the recombination characteristics at the injection level at maximum power point conditions. It is shown that under inversion conditions the implied solar cell parameters are lower compared to accumulation conditions. The main reason for this seems to be the asymmetry in defect capture cross sections for electrons and holes. As this defect characteristic at the c-Si/a-Si:H interface cannot be altered, a considerable reduction of the defect density is required to further decrease junction recombination at M PP conditions and thus increase the FF of SHJ cells
6 March 2018 in Physica Status Solidi (a)