The rapidly rising demand for energy storage systems presents an imperative need to develop sodium-ion batteries with high energy density, high conductivity, and low barrier energy. In this work, we present a Density Functional study on the properties of two-dimensional NaxSiS as a promising anode material for rechargeable sodium-ion batteries. Energetically stable structures of Na-adsorbed silicene sulfide NaxSiS with various Na contents were explored. It is found that the adsorption energy of a Na atom is higher than −0.4 eV and it decreases with increasing Na content. The electronic structure of pristine silicene sulfide shows semiconductor behaviour with a bandgap of 0.99 eV, while the Na-adsorbed SiS exhibits metallic characteristics. The highest theoretical capacity of 187.2 mA h g−1, which is higher than that of well-known two dimensional materials, is found in the fully intercalated phase of SiS Na0.5SiS which corresponds to per side layer. Furthermore, Na ions can diffuse along two typical pathways on the surface of SiS with a small barrier of 183 meV which is much smaller than that of the two dimensional LixSiS, NaxTiS2, and NaxMoS2. All these characteristics suggest that silicene sulfide SiS can be expected to be a promising anode material for sodium ion batteries.
It is well known that the temperature dependence of the effective magnetocrystalline anisotropy energy obeys the power law of magnetization in the Callen-Callen theory. Therefore, according to the Callen-Callen theory, the magnetocrystalline anisotropy energy is assumed to be zero at the critical temperature where the magnetization is approximately zero. This study estimates the temperature dependence of the magnetocrystalline anisotropy energy by integrating the magnetization versus magnetic field () curves, and found that the magnetocrystalline anisotropy is still finite even above the Curie temperature in the uniaxial anisotropy, whereas this does not appear in the cubic anisotropy case. The origin is the fast reduction of the anisotropy field, which is the magnetic field required to saturate the magnetization along the hard axis, in the case of cubic anisotropy. Therefore, the magnetization anisotropy and anisotropic magnetic susceptibility, which are the key factors of magnetic anisotropy, could not be established in the case of cubic anisotropy. In addition, the effect of magnetocrystalline anisotropy on magnetocaloric properties, as the difference between the entropy change curves of appears above the Curie temperature, is in good agreement with a previous experimental study. This is proof of magnetic anisotropy at slightly above Curie temperature.
The mobility and disorder in the lattice of Cu atoms as liquidlike behavior is an important characteristic affecting the thermoelectric properties of . In this study, using a theoretical model called an acanthite-like structure for at a low-temperature range, we systematically investigate the electronic structure, intrinsic defect formation, and transport properties by first-principles calculations. Therefore, previous experimental reports on the indirect band-gap nature of were confirmed in this work with an energy gap of about 0.9–0.95 eV. As a result, the optical absorption coefficient estimated from this model also gives a potential value of in the visible spectrum range. According to the bonding analysis and formation energy aspect, Cu vacancy is the most preferred defect to form in , which primarily affects the conductive behavior as a type, as experimentally observed. Finally, the transport properties of system were successfully reproduced using an electron-phonon scattering method, highlighting the important role of relaxation time prediction in conductivity estimation instead of regarding it as a constant.
15 March 2020 in Journal of the Physical Society of Japan
We calculated spin-wave dispersion of ferromagnetic Heusler alloys; Cu2MnAl, Ni2MnSn, and Pd2MnSn from the dynamical spin susceptibility based on the ground states determined by the quasi-particle ...