Brian E. McCandless

Brian E. McCandless

Auto-generated profile, based on publicly available information

Brian E. McCandless

Institute of Energy Conversion, University of Delaware, Newark, DE, USA

Research Focus & Metrics

Academic Career Length

35Years (1992-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
28 September 2018 in Scientific Reports
Verified
Journal Article
Open access
PDF file
BMBrian E. McCandless
Brian E. McCandless
WBWayne A. Buchanan
Wayne A. Buchanan
CTChristopher P. Thompson
Christopher P. Thompson
GSGowri Sriramagiri
Gowri Sriramagiri
RLRobert J. Lovelett
Robert J. Lovelett
WMWyatt K. Metzger
Wyatt K. Metzger
Thin film materials for photovoltaics such as cadmium telluride (CdTe), copper-indium diselenide-based chalcopyrites (CIGS), and lead iodide-based perovskites offer the potential of lower solar module capital costs and improved performance to microcrystalline silicon. However, for decades understanding and controlling hole and electron concentration in these polycrystalline films has been extremely challenging and limiting. Ionic bonding between constituent atoms often leads to tenacious intrinsic compensating defect chemistries that are difficult to control. Device modeling indicates that increasing CdTe hole density while retaining carrier lifetimes of several nanoseconds can increase solar cell efficiency to 25%. This paper describes in-situ Sb, As, and P doping and post-growth annealing that increases hole density from historic 1014 limits to 1016–1017 cm−3 levels without compromising lifetime in thin polycrystalline CdTe films, which opens paths to advance solar performance and achieve costs below conventional electricity sources.

1 October 2007 in Journal of Applied Physics
Verified
Journal Article
Closed access
GHG. M. Hanket
G. M. Hanket
WSW. N. Shafarman
W. N. Shafarman
BMB. E. McCandless
B. E. McCandless
RBR. W. Birkmire
R. W. Birkmire
The reaction pathways to form Cu(InGa)Se2 or Cu(InGa)S2 films at 450°C from metallic precursors were evaluated by reacting Cu–In–Ga films in H2Se or H2S for 10, 30, or 90min and characterizing the phase composition of the resulting films. A starting composition comprising Cu9(In0.64Ga0.36)4 and In phases was detected by x-ray diffraction in Cu–Ga–In precursors annealed at 450°C in an Ar atmosphere. When the precursors were reacted in H2Se, a graded Cu(InGa)Se2 film was formed with a Ga-rich composition and residual Cu–Ga intermetallics at the interface with the Mo back contact. The intermetallic compounds were observed to evolve from Cu9(In0.64Ga0.36)4 to Cu9Ga4 with increasing selenization time. Reaction in H2S formed inhomogeneous Cu(InGa)S2 with Cu–In intermetallics. The results are consistent with thermochemical predictions of the preferential reaction of In with Se, and Ga with S. These reaction preferences can explain the formation of a graded Cu(InGa)Se2 film during reaction in H2Se and provide a refined understanding of the reaction sequence in two-step H2Se∕H2S processes.

25 April 2003
Verified
Book Chapter
Closed access
PDF file
BMBrian E. McCandless
Brian E. McCandless
JSJames R. Sites
James R. Sites

21 December 2010
Verified
Book Chapter
Closed access
PDF file
BMBrian E. McCandless
Brian E. McCandless
JSJames R. Sites
James R. Sites

1 May 2001 in Thin Solid Films
Verified
Journal Article
Closed access
MEM. Engelmann
M. Engelmann
BMB.E. McCandless
B.E. McCandless
RBR.W. Birkmire
R.W. Birkmire

20 March 2019 in IEEE Journal of Photovoltaics
Verified
Journal Article
Closed access
BMBrian McCandless
Brian McCandless
WMWyatt K. Metzger
Wyatt K. Metzger
WBWayne Buchanan
Wayne Buchanan
GSGowri Sriramagiri
Gowri Sriramagiri
CTChristopher Thompson
Christopher Thompson
MAM. Al-Jassim
M. Al-Jassim