Direct hydroxylation of benzene to phenol using molecular oxygen is a green route with high atom economy but still a great challenge when compared with the existing method of production. The activation of oxygen is necessary and reductive agents were used to activate dioxygen in a so-called “reductive activation” process. Here, nano vanadium oxides that consist mainly of low valence vanadium to activate dioxygen were prepared under different conditions via a hydrothermal method. Under the optimized conditions, an excellent phenol selectivity of 96.3% with benzene conversion of 4.2% was achieved over the VOC2O4–N-5 without reductive agents. Characterizations revealed that VOC2O4–N-5 was composed of a mesoporous nanosphere structure with medium strong acid sites and low valence vanadium species. A mechanism was proposed as follows: dioxygen was activated by low valence vanadium in VOC2O4–N-5 to produce the active oxygen species which oxidized acetic acid to peracetic acid. Then the active oxygen species was subsequently transferred from peracetic acid to benzene and inserted into the C–H bond to give phenol.
The mesoscopic dendrite growth model in the solidification process of molten steel is established, based on the cellular automata model. To accurately describe the TiN nucleation process, a heterogeneous nucleation model was used to describe the TiN nucleation process. The accuracy of the dendrite growth model is verified by comparing the CA model and Lipton–Glicksman–Kurz (LGK) analytical model. The growth process of TiN precipitates was simulated by dynamic mesh generation. Meanwhile, the influence of grid anisotropy on dendrite growth is greatly weakened by introducing the decentered square algorithm, and the growth of the equiaxed crystal in all directions is simulated. The results show that the calculated results of the model are in good agreement with the volume and morphology of TiN observed in the experiment. Meanwhile, it is found that the smaller TiN will dissolve at the end of solidification, and there will be a re-precipitation. The precipitation time of High-N and High-Ti alloy systems with the same concentration product is basically the same, but the final precipitation solid fraction of TiN inclusions in High-N (small Ti/N) alloy is larger. N element is the decisive factor of TiN precipitation.
11 March 2011 in Journal of Chemical & Engineering Data