This paper presents a newly developed simulation-based approach for Bayesian model updating, model class selection, and model averaging called the transitional Markov chain Monte Carlo (TMCMC) approach. The idea behind TMCMC is to avoid the problem of sampling from difficult target probability density functions (PDFs) but sampling from a series of intermediate PDFs that converge to the target PDF and are easier to sample. The TMCMC approach is motivated by the adaptive Metropolis–Hastings method developed by Beck and Au in 2002 and is based on Markov chain Monte Carlo. It is shown that TMCMC is able to draw samples from some difficult PDFs (e.g., multimodal PDFs, very peaked PDFs, and PDFs with flat manifold). The TMCMC approach can also estimate evidence of the chosen probabilistic model class conditioning on the measured data, a key component for Bayesian model class selection and model averaging. Three examples are used to demonstrate the effectiveness of the TMCMC approach in Bayesian model updating, ...
Evaluating the reliability of a slope is a challenging task because the possible slip surface is not known beforehand. Approximate methods via the first-order reliability method provide efficient ways of evaluating failure probability of the “most probable” failure surface. The tradeoff is that the failure probability estimates may be biased towards the unconservative side. The Monte Carlo simulation (MCS) is a viable unbiased way of estimating the failure probability of a slope, but MCS is inefficient for problems with small failure probabilities. This study proposes a novel way based on the importance sampling technique of estimating slope reliability that is unbiased and yet is much more efficient than MCS. In particular, the critical issue of the specification of the importance sampling probability density function will be addressed in detail. Three examples of slope reliability will be used to demonstrate the performance of the new method.
1 December 2020 in ASCE-ASME Journal of Risk and Uncertainty in Engineering Systems, Part A: Civil Engineering
This study compiles a large database of 10 clay parameters (labeled as CLAY/10/7490) from 251 studies, covering clay data from 30 regions or countries worldwide. Hence, the range of data covered by this “global” database is broader than that underlying the calibration of existing transformation models in the literature. These transformation models relate test measurements (e.g., cone tip resistance) to appropriate design parameters (e.g., undrained shear strength). The correlation behaviours exhibited by the database among the 10 clay parameters are consistent with those exhibited by existing transformation models in the literature. The biases and transformation uncertainties of these transformation models with respect to the global database are calibrated. It is found that more recent transformation models are less biased and that the transformation uncertainties are typically fairly large. Such large transformation uncertainties are further reduced by incorporating secondary input parameters, such as plasticity index or sensitivity. In a companion paper written by the same authors, a 10-dimensional multivariate probability distribution coupling these clay parameters is constructed from CLAY/10/7490 and a useful application involving updating the entire bivariate probability distribution of two design parameters from three separate measurements is presented.