The on-site Coulomb potential, , and the covalent state of electronic orbitals play key roles for the Cooper pair symmetry and exotic electromagnetic properties of high- superconducting cuprates. In this paper, we demonstrate a way to determine the value of and present the whole picture of the covalent state of Cu spins in the mother system of the La-based high- superconducting cuprate, , by combining the muon spin rotation and the density functional theory (DFT) calculation. We reveal local deformations of the octahedron followed by changes in Cu-spin distributions caused by the injected muon. Adjusting the DFT and results, and the minimum charge-transfer energy between the upper Hubbard band and the O band were optimized to be 4.87(4) and 1.24(1) eV, respectively.
16 August 2021 in SAR and QSAR in Environmental Research
SARS-CoV-2 PLpro was investigated as a therapeutic target for potent antiviral drugs due to its essential role in not only viral replication but also in regulating the inborn immune response. Several computational approaches, including homology modelling, molecular docking, and molecular dynamics (MD) studies, were employed to search for promising drugs in treating SARS-CoV-2. Eighty-one compounds, sub-structurally similar to the antiviral drug, were used as potential inhibitors of PLpro. From our results, three complexes containing the ligands with Pubchem IDs: 153012995, 12149203, and 123608715 showed lower binding energies than the control (Ritonavir), indicating that they may become promising inhibitors for PLpro. MD was performed in a water solvent to validate the stability of the three complexes. All complexes achieved stable structure during the simulation as no significant fluctuations were observed in the validation parameters. Moreover, the binding energy for each complex was estimated using the MM-GBSA method. Complex 1 was the most stable structure based on the lowest binding energy score and its structure remained in a similar cavity with the docket snapshot. Based on our studies, three ligands were assumed to be potential inhibitors. The ligand of complex 1 may become the most promising antiviral drug against SARS-CoV-2 targeting PLpro.
1 December 2025 in Indonesian Journal of Chemistry
This study explores the sustainable synthesis and structural characterization of carbon, graphite, graphene oxide (GO), and reduced graphene oxide (rGO) derived from coconut shells. The objective is to investigate the potential of biomass-based precursors to produce functional carbon materials through controlled chemical treatments. X-ray diffraction patterns of carbon and graphite exhibit broad peaks, indicating low crystallinity and amorphous characteristics, while GO and rGO show dominant peaks at 22° and 23°, corresponding to the (002) plane. Scanning electron microscopy confirms the disordered morphology of carbon and graphite, while high-resolution transmission electron microscopy reveals wrinkled GO sheets and partially restacked rGO layers. Fourier transform infrared spectra identify O−H stretching at ~3442 cm−1 in carbon and C=C stretching at 1630 cm−1 in graphite, along with various oxygen-containing functional groups in GO and rGO. Raman spectroscopy shows a sharp G band at 1580 cm−1 in graphite (ID/IG = 0.840), increased disorder in GO (ID/IG = 0.843), and partial graphitic restoration in rGO (ID/IG = 0.841). These findings confirm the successful transformation of coconut shells into valuable carbon-based materials and highlight their potential for use in sustainable energy and electronic applications.
8 January 2026 in Journal of Physics and Its Applications
Plastic pollution continues to pose a serious environmental challenge due to the persistence of petroleum-based polymers in ecosystems. Starch-based bioplastics offer a biodegradable alternative; however, their practical application is limited by low mechanical strength and high water absorption. This study investigates the effect of pepper stem waste fiber (Piper nigrum) reinforcement and fiber orientation (aligned vs. random) on the mechanical properties, water absorption, and biodegradation behavior of cassava starch films. Bioplastic films were prepared in three formulations: control (without fibers), aligned fiber reinforcement (AFR), and random fiber reinforcement (RFR). Structural and performance evaluations were conducted using X-ray diffraction (XRD), tensile testing, water absorption analysis, and soil burial biodegradation (8 cm depth). XRD patterns confirmed semi-crystalline starch structures with characteristic peaks at 2θ ≈ 17°, 19°, and 22°. Tensile strength increased from 0.6957 MPa (control) to 0.7873 MPa (AFR), corresponding to a 13.2% improvement, indicating enhanced load transfer in aligned fiber structures. Water absorption decreased from 70% (control) to 50% (RFR), showing a 28.6% reduction, likely due to increased tortuosity of water diffusion pathways. Soil burial testing showed rapid degradation, reaching 28.37% mass loss by day 3 and 100% mass loss/disintegration by day 6 under the tested conditions. Overall, pepper stem fibers improve the performance of cassava starch films while maintaining rapid biodegradability, highlighting their potential for environmentally friendly disposable and packaging applications.
The learning activities at SMAN 2 Palopo have not yet maximized by using of multimedia in the classroom learning process. Based on the results of interviews and observations at SMAN 2 Palopo, teachers only used PowerPoint downloaded from the internet and the teacher only made a few adjustments. This causes learning activities was not be able to attract students' attention. On the other hand, students spend a lot of time with smartphones. Observation results show that most students already have Android-based smartphones. This community service activity will increase the capacity of teachers in designing Android-based interactive multimedia. This multimedia allows students to access learning material via smartphone at anytime and anywhere. Implementation of the activity started with a focus group discussion (FGD) followed by a learning design workshop and Android-based interactive multimedia. This workshop was followed up with teacher assistance in designing interactive multimedia accompanied by the application of multimedia in the learning process. At the end of each lesson, reflection is carried out to see deficiencies in both the process and interactive multimedia. Based on the FGD activities carried out, teachers have never designed Android-based multimedia and do not have the competence to design Android-based multimedia. After going through a series of workshops and assistance with multimedia design, teachers were able to design Android-based interactive multimedia for use in learning. This assistance was carried out for four weeks for 4 meetings. The teacher stated that the ability to design multimedia has improved every week and hopes that this can continue. Based on the student response questionnaire, the multimedia used is easy to install and use, the appearance is attractive, and the material coverage is complete along with student worksheets. In this service activity, the teacher's ability to design Android-based interactive multimedia has increased, which has resulted in increased student learning activities in class.