18 May 2000 in Journal of the American Chemical Society
1 January 2014 in Physics Procedia
This paper focuses on high-speed optical MEMS Scanners and Micro Mirror Arrays. Devices supporting spot/pixel rateshigher than 10 Mpixel/s are considered and discussed regarding limits and possibilities to further improve speed and optical properties. Several variants of both types, developed by our group, are presented. Scanning Micro Mirrors with frequencies up to 100 kHz enable spot rates of up to 130 Mpixels / s at 650 nm. Bragg-coatings enable high power applications up to 20 W (beam ø2 mm). Challenges like static and dynamic mirror planariy are discussed. A 29-kHz-scanner for laser projection serves as application example. Highly parallel operated Micro Mirror Arrays extend pattern speed to 10 Gpixel / s including analog grey scaling. Irradiation tests prove stable operation of the mirrors at DUV. Prospects regarding optical planarity and high reflective coatings are discussed. By means of two examples, laser patterning of semiconductor masks and laser patterning of Printed Circuit Boards, properties of the spatial light modulators are presented. The two device classes are compared regarding spot/pixel rate and frequency. The comparison includes representative MEMS device examples from literature
15 March 2000 in Journal of Applied Physics
We report a very good force resolution for tuning fork based shear force microscopy as used for feedback regulation in scanning near-field optical microcopy (NSOM). The sensitivity and dynamics of fiber tips attached to 100 kHz tuning forks are investigated both experimentally and theoretically applying a finite element analysis. Operating the tuning fork at vibration amplitudes smaller than 10 nm allows to discriminate between viscous damping due to capillary wetting, and fiber bending upon tip-sample approach to hydrophilic sample surfaces indicating the direct transition from “noncontact operation” (pure viscous damping due to contamination layer) down to tip-sample contact. Viscous damping manifests in frequency shifts of less than 50 mHz, as deduced from resonance curves recorded under feedback control. For relative amplitude changes of less than 0.5% the viscous damping force acting lateral on the fiber tip is calculated to ∼100 pN using the finite element method. This detection limit proves that tuning fork based shear force control is superior to other feedback mechanisms employed in NSOM.
1 June 1999 in Electrochimica Acta
26 October 2018 in Thin Solid Films