An experimental study of the switching and tuning of optical fiber ring lasers is presented. The laser wavelength switching and tuning are based on the modifiable wavelength dependent losses of a modal Michelson interferometer, which is composed by a bi-conical fiber taper spliced with a single-mode fiber piece. The wavelength dependent losses of the interferometer are inserted in a ring cavity laser to allow wavelength selection of laser wavelength peaks which induce preferences to generate laser emissions. By altering the interferometer geometrical dimensions, such as the single mode fiber piece length, and the curvature of the interferometer structure, the cavity losses can be adjusted to control the number of output laser wavelength peaks and also to cause wavelength shift of the output laser peaks, respectively. A maxim number of wavelength peaks of 13, and a maximum wavelength tuning by displacement-curvature of ∼2.3 nm mm −1 were obtained with maximum OSNR values of around 50 dBm.
A straightforward and versatile method for switching from single to different multiwavelength laser emission in ring cavity fiber lasers is proposed and demonstrated experimentally. The method is based on using the changeable interference pattern from an optical fiber modal Michelson interferometer as a wavelength selective filter into the ring cavity laser. The interferometer is constructed using a bi-conical tapered fiber and a single-mode fiber segment, with these being spliced together to form an optical fiber tip probe. When the length of the single-mode fiber piece is modified, the phase difference between the interfering modes of the interferometer causes a change in the interferometer free spectral range. As a consequence, the laser intra-cavity losses lead to gain competition, which allows us to adjust the number of simultaneously generated laser lines. A multiwavelength reconfiguration of the laser from one up to a maximum of eight emission lines was obtained, with a maximum SNR of around 47 dBm.
20 August 2013 in International Journal of Systems Science
An optical fiber refractive index (RI) sensor based on a single-mode–multimode–single mode (SMS) fiber structure fabricated with a coreless low-index multimode fiber (CLIMF) tapered to several diameters is presented. Both the response to changes in the external RI and its spectral dependence were strongly influenced by the length and diameter of the CLIMF. Different SMS sensors with diameters of 120, 100, 80, 60, 40 μm and the corresponding reimaging lengths at 1550 nm are immersed in RI of 1.32, 1.34, 1.36, 1.39, and 1.42 to study the response to changes in the external RI. The diameter of 80 μm yields the best sensitivity (540.7 nm / RIU) with a resolution of 6 × 10 − 5 in the RI range 1.32 to 1.39. By duplicating the reimaging length at 1550 nm for this diameter, the RI range increased to 1.42 and a maximum sensitivity of 1022 nm / RIU is achieved in the RI range from 1.39 to 1.42. Also the simulation results corroborate the wavelength positions of the peaks of the experimental spectrums. We show that the response range to changes in the external RI is controlled with the SMS geometry. This advantage makes the SMS sensor very suitable for biological applications.
21 January 2013 in International Journal of Systems Science