Dynamic parameterization of the statistical characteristics of structural systems’ measured input and output data is an important task for the digital twin modeling and intelligent risk assessment of transportation infrastructures. Characteristics of mixed skewness probability are common in structural systems, and its extreme value represents the risk state closest to the critical limit. The generalized extreme value mixture model (GEVMM) can consider multiple factors that interfere with each other, based on which the generalized maximum likelihood estimation (GMLE) of full Bayesian is introduced. The proposed GMLE-GEVMM can conduct the modeling of mixed skewness probability (mainly including strong uni-factor and multi-factor statistical characteristics) by fusing the prior physical information for each parameter. A reliable paradigm for predicting the dynamic extreme value of practical engineering is presented. The proposed methods can overcome the probabilistic modeling problem for complex mixed skewness characteristics, and significantly improve the prediction accuracy of the extreme value of probability. The continuous monitoring data from a real bridge is used for validation. The modeling and predicting results verified the proposed methods’ strong applicability and high accuracy for complex probabilistic system input and output characteristics from in-service structures.
A health monitoring system typically collects and processes data to observe the health status of a bridge. The cost limitations imply that only the measurement point data of a few key points can be obtained; however, the entire bridge monitoring information cannot be established, which significantly interferes with the data integrity of the structural monitoring system. In this study, a solution is proposed for reconstructing the monitoring data of the entire bridge. By updating the finite element (FE) model based on structural thermal analysis, numerical simulation technology, and other methods, the temperature field integration model of a cable-stayed bridge is realized. The temperature spatial expansion method of deep learning is established by using the complete simulated temperature field of the entire bridge based on limited measured temperature data; this data is verified and applied to the main beam and bridge tower, thereby establishing the complete measured temperature field of the whole bridge. This is of great significance in supplementing health monitoring information, allowing for the accurate monitoring and evaluation of the structural safety and service performance of long bridges.
Hidden risks of service state of urban lifeline infrastructures under the complex environment or load are public safety information that must always be available. The point-measuring sensors commonly ...
Rapid underground development in cities increases the hidden risks of roadbed cavities. Traditional geophysical methods, such as ground-penetrating radar (GPR), are costly and unsuitable for automated large-scale monitoring. This paper proposes a distributed-acoustic-sensing (DAS)-based algorithm for urban road cavity monitoring using vehicle-induced vibration signals. By leveraging routine urban traffic as a natural excitation source and DAS as the sensing medium, automated and continuous perception of subsurface-cavity hazards is achieved. A time–frequency joint vehicle-signal extraction algorithm is introduced to reliably isolate vehicle responses under complex noise conditions, and a physically interpretable Average Feature Ratio Indicator (AFRI) is constructed to identify long-term distribution shifts associated with structural anomalies. The AFRI remains highly stable within a narrow 0.70–1.00 range on cavity-free roads, even under low-level false positives (~1%). Experimental validation further shows that anomalous responses extend approximately 5 m from the cavity center. These findings confirm both the feasibility of the proposed method and its potential for practical early warning of subsurface cavities in urban road infrastructure.