In recent times, the world has been on a quest for clean and sustainable forms of energy, which has strongly driven research on photovoltaic (PV) systems, particularly on their electrical characteristics. This study addresses these challenges by proposing a hybrid analytical–numerical method for the accurate extraction of the parameters of the single-diode model (SDM) and double-diode model (DDM), with the introduction of an Equation Validity Condition (EVC). The EVC provides an additional validation and correction phase by directly coordinating the five unknown parameters in the SDM and the seven unknown parameters in the DDM, thus preserving physical consistency, improving numerical stability, and significantly reducing computational time. The method is validated using benchmark PV devices, achieving low RMSE values across all devices. In addition, the proposed EVC based approach achieves substantial reductions in computation time. Further robustness analysis is conducted on Shellvarious monocrystalline, polycrystalline, and thin-film modules under different irradiance and temperature conditions for both models. The results show a strong agreement between experimental and simulated I–V characteristics and consistently outperform recent state-of-the-art methods.
Current signature analysis (CSA) has emerged as a promising non-intrusive technique for monitoring the operational behavior of embedded systems through their power consumption. However, the effectiveness of CSA fundamentally depends on the availability of a measurement platform capable of acquiring current variations with sufficient precision, repeatability, and low electromagnetic noise to reliably resolve the amplitude ranges relevant to the target application. This paper presents the design, implementation, and experimental validation of a low-cost dedicated embedded platform for precision current signature acquisition. The proposed system is built around an STM32 microcontroller coupled with an INA226 digital current sensor, integrated on a custom four-layer printed circuit board (PCB) specifically optimized for signal integrity and electromagnetic compatibility. The hardware architecture incorporates carefully designed clock circuits, appropriate power regulation, analog filtering, Kelvin sensing, multilayer grounding, and optimized PCB layout to ensure measurement reliability. A lightweight bare-metal firmware performs synchronized current acquisition via the I 2 C interface and streams timestamped data to a host computer through USB CDC. The platform is experimentally evaluated under controlled operating conditions, including idle-state and GPIO-controlled load-switching scenarios. The results demonstrate low measurement noise, excellent repeatability, reliable load-state discrimination, and accurate transient detection, confirming the suitability of the proposed platform for current signature acquisition to support future research on low-frequency fault and anomaly detection.