2 November 2017 in Journal of Taibah University for Science
Wastewater containing heavy metals, such as nickel ions (Ni2+), discharged from industry to water streams poses a serious threat because even at low concentrations, it does not naturally degrade and is toxic to human and aquatic life. This article reviews a novel technique for wastewater treatment using a Sayong ball clay (SBC) membrane to remove nickel from industrial wastewater. SBC powder was achieved through milling using a planetary ball mill (milling time; 10, 20 and 30Â h), further labelled as SBC 10, SBC 20 and SBC 30, with a ball-to-powder of ratio 7:1 and rotation speed of 300Â rpm. The physical characteristics of the apparent porosities, bulk density and shrinkage were investigated. XRD was used to study the phase, while FESEM was used to analyse the microstructure of the fired membrane. The FESEM microstructure indicates a decreased particle size (SB30). Filtration was conducted using a dead-end filtration system. The fabricated SBC 10, 20 and 30 membranes showed significant removal of nickel from industrial wastewaterâ88.87%, 82.96% and 85.13%, respectively. This study revealed that the SBC membrane is a promising membrane to remove nickel from industrial wastewater. The results also indicate the possibility of highlighting the introduced technique as a new technique for the treatment of industrial wastewater. As a new trend for waste management, pollution prevention could be applied in Malaysia as one of the advanced biotechnologies to solve various environmental problems. Keywords: environmental management, wastewater treatment, waste processing, heavy metal
1 October 2016 in Case Studies in Engineering Failure Analysis
Incident involving failures of ASTM A53 carbon steel (CS) pipe, connected to pressure safety valve (PSV) and carrying raw gas has caused serious supply disruption. This study was performed to identify the most probable cause of the pipe failure. It was conducted by reviewing the existing design, construction data and pipe material analysis using non-destructive techniques such as VT, PT, MT and UT along with metallographic, hardness and microscopic analysis. The investigation revealed that excessive material loss has occurred in both failure and its adjacent regions due to abrasive grinding, resulting in the formation of a through thickness flaw. These grindings were performed to accommodate the pre-installed piping spool to avoid alteration in the pipe position. RCA demonstrated that this rapid thinning of the steel pipe body later led to its failure. Metallurgical study using photomicrograph shows that the morphology of the steel material was consistent and did not show any evidence of internal corrosion or micro fractures. Further damage to the surface of already excessively reduced thickness occurred due to nominal pipe vibration and atmospheric effect during service. The research work described in the paper has a significant meaning to recognize the root cause of such failures in CS pipes and through given recommendations to eliminate future such happenings
19 October 2022 in Journal of Failure Analysis and Prevention