Juan Jurado

Juan Jurado

Auto-generated profile, based on publicly available information

Juan Jurado

U.S. Air Force, Edwards, CA, USA

Research Focus & Metrics

Academic Career Length

10Years (2017-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
20 June 2024 in IEEE Transactions on Intelligent Transportation Systems
Verified
Journal Article
Closed access
ZKZak Kassas
Zak Kassas
NKNadim Khairallah
Nadim Khairallah
JKJoe Khalife
Joe Khalife
CLChiawei Lee
Chiawei Lee
JJJuan Jurado
Juan Jurado
RTRunXuan Tay
RunXuan Tay
A radio simultaneous localization and mapping (radio SLAM) framework enabling aircraft navigation with terrestrial signals of opportunity (SOPs) is presented and experimentally validated. The framework does not assume availability of global navigation satellite system (GNSS) signals. Instead, it assumes the aircraft to have an initial estimate of its own states, after which it navigates by exploiting pseudorange measurements extracted from terrestrial SOPs, while estimating the states of the aircraft simultaneously with the SOPs’ states. Two radio SLAM frameworks are presented: (i) tightly-coupled SOP-aided inertial navigation system (INS) and (ii) utilizing a Wiener process acceleration (WPA) dynamical model for the aircraft’s dynamics instead of the INS. Results from four flight runs on a US Air Force C-12 aircraft, equipped with an altimeter and an industrial-grade inertial measurement unit (IMU), are presented. The flight runs took place over semi-urban (SU), urban (U), and rural (R) regions in California, USA; while exercising different aircraft maneuvers: holding (H), descending (D), and grid (G). Different a priori conditions of the SOPs’ positions were studied: from all unknown, to some known, to all known. In all cases, the SOPs’ clock error states (bias and drift) were unknown and estimated alongside the aircraft’s states. The results consistently demonstrated the promise of real-world aircraft navigation via radio SLAM, yielding bounded errors along trajectories of tens of kilometers. The three-dimensional (3–D) position root-mean squared errors (RMSEs) are summarized next, where $N$ denotes the number of SOPs exploited along the trajectory: (1) SU, H, INS-SOP, $N=6$ , 56.7 km in 8.5 minutes, maximum altitude of 5,577 ft: 43.27 m with all unknown and 10.14 m with all known; (2) U, H, INS-SOP, $N=6$ , 72.7 km in 12.9 minutes, maximum altitude of 5,906 ft: 89.82 m with all unknown and 16.97 m with all known; (3) SU, D, WPA-SOP, $N=18$ , 111.9 km in 20.0 minutes, maximum altitude of 6,234 ft: 36.42 m with all unknown and 18.62 m with all known; and (4) R, G, WPA-SOP, $N=32$ , 78.4 km in 13.8 minutes, maximum altitude of 7,546 ft: 67.01 m with all unknown and 25.65 m with all known.

29 June 2022 in IEEE Aerospace and Electronic Systems Magazine
Verified
Journal Article
Closed access
ZKZak Kassas
Zak Kassas
JKJoe Khalife
Joe Khalife
AAAli Abdallah
Ali Abdallah
CLChiawei Lee
Chiawei Lee
JJJuan Jurado
Juan Jurado
RTRunXuan Tay
RunXuan Tay
Opportunistic navigation with cellular signals is studied and demonstrated on a high-altitude aircraft. An extensive campaign was conducted by the Autonomous Systems Perception, Intelligence, and Navigation Laboratory (ASPIN) in collaboration with the U.S. Air Force (USAF) to sample ambient cellular signals of opportunity (SOPs) at different altitudes in different regions in Southern California, USA. The carrier-to-noise ratio is characterized as a function of altitude and horizontal distance. It was found that signals from cellular transmitters can be reliably acquired and tracked for navigation purposes by receivers mounted on high dynamics aircraft flying at altitudes as high as 23,000 ft above ground level and horizontal distances as far as 100 km. The multipath channel is also characterized as a function of altitude, showing clean channels with a dominant line-of-sight component for altitudes up to 23,000 ft. To further assess the potential of cellular SOPs for aircraft navigation, a 51-km trajectory traversed over a period of 9 minutes was estimated exclusively using cellular SOPs (i.e., with no GPS or other sensors, except for barometric altimeter measurements), resulting in a three-dimensional position (3-D) 10.5-m position root-mean-squared error.

25 August 2020 in NAVIGATION: Journal of the Institute of Navigation
Verified
Journal Article
Closed access
PDF file
JJJuan Jurado
Juan Jurado
JRJohn Raquet
John Raquet
CKChristine M. Schubert Kabban
Christine M. Schubert Kabban
JGJonathon Gipson
Jonathon Gipson
All-source navigation has become increasingly relevant over the past decade with the development of viable alternative sensor technologies. However, as the number and type of sensors informing a system increases, so does the probability of corrupting the system with sensor modeling errors, signal interference, and undetected faults. Though the latter of these has been extensively researched, the majority of existing approaches have constrained faults to biases and designed algorithms centered around the assumption of simultaneously redundant, synchronous sensors with valid measurement models, none of which are guaranteed for all-source systems. As part of an overall all-source assured or resilient navigation objective, this research contributes a fault- and sensor-agnostic fault detection and exclusion method that can provide the user with performance guarantees without constraining the statistical distribution of the fault. The proposed method is compared against normalized solution separation approaches using Monte-Carlo simulations in a 2D non-GPS navigation problem.

20 January 2019 in NAVIGATION: Journal of the Institute of Navigation
Verified
Journal Article
Open access
PDF file
JJJuan Jurado
Juan Jurado
CKChristine M. Schubert Kabban
Christine M. Schubert Kabban
JRJohn Raquet
John Raquet
This research proposes a novel, autonomous, regression‐based methodology for Allan variance analysis of inertial measurement unit (IMU) sensors. Current methods for Allan variance analysis have been rooted in the human‐based interpretation of linear trends, referred to as the slope method. The slope method is so prolific; it is referenced among electrical and electronics engineering standards for IMU error analysis. However, the graphical nature and visual‐inspection–based use of the method limit its ability to be programmed as a generalized algorithm, which hinders the autonomy desired in modern‐day navigation computations. Using nonlinear regression with a ridge‐regression initial guess, the proposed method is shown to produce comparable results to the gold standard slope method when using standard‐length data collections and outperforms the slope method when the amount of available data is limited. This development directly enables accurate navigation solutions for all vehicles in land, air, sea, and space operations.

21 July 2020 in IEEE Transactions on Aerospace and Electronic Systems
Verified
Journal Article
Closed access
JJJuan Jurado
Juan Jurado
JRJohn Raquet
John Raquet
CKChristine M. Schubert Kabban
Christine M. Schubert Kabban
All-source navigation has become increasingly relevant over the past decade with the development of viable alternative sensor technologies. However, as the number and type of sensors informing a system increases, so does the probability of corrupting the system with sensor modeling errors, signal interference, and undetected faults. Though the latter of these has been extensively researched, the majority of existing approaches have designed algorithms centered around the assumption of simultaneously redundant, synchronous sensors with well-understood measurement models, none of which are guaranteed for all-source systems. As part of an overall all-source assured or resilient navigation objective, this research contributes a key component - validation of sensors which have questionable sensor models, in a fault-agnostic and sensor-agnostic manner, and without compromising the ongoing navigation solution in the process. The proposed algorithm combines a residual-based test statistic with the partial update formulation of the Kalman- Schmidt filter to provide a reliable method for sensor model validation that protects the integrity of the navigation solution during the validation process, all using only a single existing filter. The performance of the proposed method is validated against traditional fault detection and exclusion methods (such as normalized solution separation and conventional residual sequence monitoring) using Monte-Carlo simulations in a 2D non-GPS navigation problem with a plug-and-play position sensor.

8 April 2020 in IEEE Transactions on Instrumentation and Measurement
Verified
Journal Article
Closed access
SGStephane Guerrier
Stephane Guerrier
JJJuan Jurado
Juan Jurado
MKMehran Khaghani
Mehran Khaghani
GBGaetan Bakalli
Gaetan Bakalli
MKMucyo Karemera
Mucyo Karemera
YZYuming Zhang
Yuming Zhang
The task of inertial sensor calibration has required the development of various techniques to take into account the sources of measurement error coming from such devices. The calibration of the stochastic errors of these sensors has been the focus of increasing amount of research in which the method of reference has been the so-called “Allan variance slope method” which, in addition to not having appropriate statistical properties, requires a subjective input which makes it prone to mistakes. To overcome this, recent research has started proposing “automatic” approaches where the parameters of the probabilistic models underlying the error signals are estimated by matching functions of the Allan variance or Wavelet Variance with their modelimplied counterparts. However, given the increased use of such techniques, there has been no study or clear direction for practitioners on which approach is optimal for the purpose of sensor calibration. This paper, for the first time, formally defines the class of estimators based on this technique and puts forward theoretical and applied results that, comparing with estimators in this class, suggest the use of the Generalized Method of Wavelet Moments (GMWM) as an optimal choice. In addition to analytical proofs, experiment-driven Monte Carlo simulations demonstrated the superior performance of this estimator. Further analysis of error signal from a gyroscope was also provided to further motivate performing such analyses, as real-world observed error signals may show significant deviation from manufacturer-provided error models.