18 August 2020 in IEEE Transactions on Electron Devices
We report improvement of TiN/Y₂O₃/ Si0.78Ge0.22 metal-oxide-semiconductor (MOS) interface properties by employing the trimethylaluminum (TMA) pretreatment before Y₂O₃ deposition. It is found that the optimum number of the TMA pretreatment cycles for minimizing interface trap density (Dit) and slow trap density (Δ Nst) of TiN/Y₂O₃/SiGe interfaces with post metallization annealing (PMA) at 450 °C is ten cycles. The reduction in Dit and Δ Nst is attributable to less amounts of Ge-O bonds at the SiGe interfaces. On the other hand, an increase in Dit with further increasing the number of TMA pretreatment is attributable to more amounts of Al-O bonds in ILs.
12 May 2020 in Journal of Applied Physics
We investigate the influence of an interfacial layer (IL) formed by plasma pre-oxidation on atomic layer deposition TiN/Y2O3/Si0.62Ge0.38 metal–oxide–semiconductor (MOS) gate stacks on the electrical characteristics of the MOS interfaces in order to examine the physical mechanism of the interface trap density (Dit) of SiGe MOS interfaces. The post-metallization annealing (PMA) temperature significantly decreases Dit. It is found that, at any PMA temperature, Dit at the MOS interfaces without pre-oxidation is lower than that with pre-oxidation. The low Dit value of 7 × 1011 eV−1 cm−2 is obtained for TiN/Y2O3/SiGe without pre-oxidation after PMA at 450 °C. It is revealed that the ILs of TiN/Y2O3 stacks with and without pre-oxidation after PMA consist mainly of YSiOx/SiGeOx and YSiOx, respectively. The physical origins of reduction in Dit without pre-oxidation and after PMA are attributable to the reduction in the amount of Ge–O bonds at the interface and an annealing effect of distorted Ge–O bonds, respectively.
17 May 2021 in IEEE Electron Device Letters
Ultrathin equivalent oxide thickness (EOT) scaling of TiN/Y 2 O 3 /SiGe gate stacks using a trimethylaluminum (TMA) treatment was studied. In comparison to previously reported high-k/SiGe MOS interfaces utilizing various Ge contents, we obtained an EOT scaling down to 1 nm with ultralow interface trap densities ( D it ). In addition, the impact of EOT scaling on the SiGe MOS interface properties has been investigated. We found the stress-induced degradation at the SiGe interface from constant gate biasing can be suppressed by scaling the thickness of Y 2 O 3 .
1 June 2019 in Microelectronic Engineering
1 August 2021 in AIP Advances
We study the impact of the atomic layer deposition high-k gate insulators on metal–oxide–semiconductor (MOS) interface properties of Si0.78Ge0.22 gate stacks with TiN gate electrodes and the physical origins of the reduction in MOS interface defects. The SiGe MOS interface properties of TiN/Y2O3, Al2O3, HfO2, and ZrO2 gate stacks are compared over a wide range of annealing temperatures. It is found that the lowest interface trap density (Dit) is obtained by TiN/Y2O3 stacks with post-metallization annealing (PMA) at 450 °C among the gate stacks with other gate insulators. Moreover, it is revealed that less amount of GeOx in the interfacial layer leads to lower Dit and that the Y2O3 stacks yield further reduction in Dit during PMA at 450 °C. These results can be explained by the reduction in distorted Ge–O bond densities in GeOx in ILs by scavenging and annealing effects during PMA and the suppression of Ge dangling bond generation by incorporating Y atoms into GeOx during PMA at 450 °C.
23 January 2026 in IEEE Electron Device Letters
This work demonstrates the two-step elevated-temperature atomic layer deposit (ALD) process of bilayer ZrOₓ/HfOₓ relatively higher-κ dielectrics reported on chemical vapor deposit (CVD) monolayer (1L) WSe2 for top-gate dielectric. Top-gated 1L-WSe2 pFETs with a low subthreshold swing (S.S. ~60 mV/dec) are achieved at a low equivalent oxide thickness (EOT) of 0.8 nm. By scaling the physical thickness of this two-step bilayer ZrOₓ/HfOₓ dielectric with the pinhole-free AlOₓ nucleation layer down to 2 nm, the proposed gate stack exhibits a high effective dielectric constant (εeff ~14) and strong reliability (breakdown field EBD ~21 MV/cm) at the scaled EOT. This breakthrough in gate dielectric integration on p-type 1L-WSe2 enables balanced n/p performance for 2D-channel devices and enhances the feasibility of future low-power consumption CMOS applications.