1 July 2024 in Physics of Fluids
The main focus of this paper is to discover the link between flame macrostructure and thermoacoustic instability in a centrally staged swirl burner. In practical combustors, the flow rate in the pilot stage is much smaller than that in the main stage. However, the modification in the pilot stage could alter the flame macrostructure while maintaining a similar total flow rate. Therefore, the thermoacoustic instability was examined at different flame macrostructures by varying the pilot stage equivalence ratio under identical main stage inlet conditions. High-frequency planar laser measurements and chemiluminescence measurement were conducted to enhance spatial and temporal accuracy, providing a more comprehensive understanding of thermoacoustic instability. Two different flame macrostructures, S-type and I-type flames, were identified based on the preheating zone distribution. They exhibit distinct thermoacoustic instabilities, with the I-type flames demonstrating more intense instability than S-type flames. The results indicate that the variation of flame macrostructure influences the coupling of flame heat release and flow field. Specifically, the preheating zone and heat release of I-type flames exhibit greater sensitivity to flow field fluctuations, resulting in a more intense and complex fluctuation of the flame. This discrepancy leads to variations in thermoacoustic instability intensity, as well as the changes in the phase coupling between heat release and acoustic pressure, which in turn impact the total Rayleigh index. Meanwhile, significant differences exist in the distribution pattern and range of flow field fluctuations between I-type and S-type flames.
1 December 2024 in Physics of Fluids
This paper examined the influence of adjacent nozzles on the flow and fuel atomization characteristics of the central nozzle in a triple-nozzle model combustor. High-frequency particle imaging velocimetry testing for airflow and phase Doppler particle analyzer testing for fuel particles were employed. Under the central nozzle air intake mode, the momentum exchange between the swirling flow and the surrounding stationary air leads to a seemingly shrinking flow field. While under the triple nozzles air intake mode, the low static pressure at the geometric center between adjacent nozzles attracts the swirling flows to converge, resulting in a larger expansion angle. Confinement has a complex impact on swirling flow. When the angle of the swirling airflow is small, it guides the flow to expand. However, when the angle becomes too large, it restricts further expansion. Observed Sauter mean diameter (SMD) peaks for the tested cases lie within a similar range, suggesting comparable spray angles. Nevertheless, the triple-nozzle air intake mode exhibits consistently higher SMD values and significantly greater spray core penetration depth. Instantaneous flow characteristics deepen the understanding of these differences in atomization results. The large range of airflow oscillation under the central nozzle air intake mode allows the airflow to directly interact with the droplets. While under the triple-nozzle air intake mode, the air flow path is too far away from the spray, resulting in that most droplets do not receive sufficient aerodynamic forces for atomization.
1 August 2025 in Physics of Fluids
This paper presents an experimental investigation on flame interactions and macrostructures between adjacent domes in a centrally staged triple-dome model combustor under different main-stage equivalence ratio (∅m) and stratification ratio (SR) conditions. This work employs direct photograph and high-speed flame chemiluminescence of CH* and OH* measurements. The degree of interaction is quantitatively evaluated by examining the relative CH* intensity of a few key locations and comparing the intensity on the wall side with that on the adjacent dome side. Flame CH* imaging also reveals three distinct flame macrostructures (single-layer, double-layer, and triple-layer) and two inter-dome flame interaction modes [inverted V-shape (IVS) and inverted funnel-shape (IFS)]. Results demonstrate that flame macrostructures are predominantly influenced by SR variations, while interaction modes were determined solely by ∅m conditions. Compared to the IFS mode, the IVS mode shows an interaction region located closer upstream. Moreover, two distinct interaction-induced phenomena are identified: a stable outer flame in the main-stage jet outer shear layer, and an intermittent pocket flame within the inter-dome triangular recirculation zone. Analysis of local equivalence ratios and high-speed OH* image sequences shows that outer flame stabilization depends primarily on heat feedback from the sub-interaction backflow region, while the intermittent behavior of pocket flame is attributed to the periodic flame fragment detachment in the interaction region.
3 April 2026 in Combustion and Flame
1 July 2025 in Physics of Fluids
A novel 10-kHz laser-induced incandescence (LII) measurement system was developed to address the scarcity of high-frequency soot diagnostics in turbulent flames. The LII measurement was integrated with particle image velocimetry to investigate soot–turbulence interactions in turbulent non-premixed methane jet flames. Simultaneous time-resolved measurements of soot volume fraction (fv) and velocity fields were conducted in the soot formation region of flames at Reynolds numbers of 5000 and 10 000. The high-frequency LII system demonstrated excellent capability in tracking the dynamic evolution of soot structures while maintaining an adequate signal-to-noise ratio. The results of the soot dynamic evolution show that the soot evolution is driven by the vortex structure and affected by turbulent shearing and stretching effects. The joint probability density functions based on high-frequency measurement statistics show that the spatial location of the soot structure with high fv is correlated with the axial velocities of about 6–8 m/s, the relative velocities of 0–3 m/s, the shear rate around zero, the strain rate of near 300 s−1, and the vorticity below 500 s−1. The correlation patterns between the high fv soot and the turbulence properties are similar for the two flames, despite the significant difference in jet velocity. The time-resolved statistics of the fluctuation velocities demonstrate the correlation between soot formation and turbulent fluctuations. The findings emphasize that local flow field conditions governing residence time are crucial for soot formation in turbulent flames.