1 March 2010 in Bioresource Technology
23 January 2008 in Surface and Interface Analysis
In this study, activated carbons were produced from animal wastes (cow dung) by chemical activation. The effects of the activating agent and the impregnation ratio were investigated at constant temperature of 700 °C. Chemical activations were carried out by mixing the solution of ZnCl 2 or KOH and animal wastes with a chemical agent/waste, ratio (wt/wt) varying from 0.5 to 2.5. The pore properties including the Brunauer‐Emmett‐Teller(BET) surface area, pore volume, pore size distribution and average pore diameter of the activated carbons were determined by physical adsorption of N 2 at − 196 °C. The highest BET surface areas and total pore volumes were achieved as 1367 m 2 /g and 0.788 cm 3 /g for ZnCl 2 ‐activated carbon and as 1916 m 2 /g and 1.13 cm 3 /g for KOH‐activated carbon, respectively. The microstructure of the activated carbons was examined by SEM. The surface functional groups were determined by Fourier transform infrared spectra (FTIR). This study has demonstrated that high surface area activated carbons can be prepared from the chemical activation of animal wastes with KOH and ZnCl 2 as activating agents. Copyright © 2008 John Wiley & Sons, Ltd.
12 July 2021 in ACS Applied Materials & Interfaces
1 May 2003 in Water Science & Technology
Wastes have been considered to be a serious worldwide environmental problem in recent years. Because of increasing pollution, these wastes should be treated. However, industrial wastes can contain a number of valuable organic components. Recovery of these components is important economically. Using conventional distillation techniques, the separation of acetic acid and water is both impractical and uneconomical, because it often requires large number of trays and a high reflux ratio. In practice special techniques are used depending on the concentration of acetic acid. Between 30 and 70% (w/w) acetic acid contents, extractive distillation was suggested. Extractive distillation is a multicomponent-rectification method similar in purpose to azeotropic distillation. In extractive distillation, to a binary mixture which is difficult or impossible to separate by ordinary means, a third component termed an entrainer is added which alters the relative volatility of the original constituents, thus permitting the separation. In our department acetic acid is used as a solvent during the obtaining of cobalt(III) acetate from cobalt(II) acetate by an electrochemical method. After the operation, the remaining waste contains acetic acid. In this work, acetic acid which has been found in this waste was recovered by extractive distillation. Adiponitrile and sulfolane were used as high boiling solvents and the effects of solvent feed rate/ solution feed rate ratio and solvent type were investigated. According to the experimental results, it was seem that the recovery of acetic acid from waste streams is possible by extractive distillation.
16 March 2010 in Surface and Interface Analysis
1 June 2020 in New Carbon Materials