3 June 2015 in Philosophical Magazine Letters
We investigated the roles of deformation-induced ε-martensitic transformation on strain-controlled low-cycle fatigue (LCF) through crack-propagation analysis involving a notching technique that used a focused ion beam (FIB) setup on Fe–30Mn–4Si–2Al austenitic steel. Using the FIB notch, we separated the microstructure evolution into macroscopic cyclic deformation-induced and crack-propagation-induced microstructures. Following this, we clarified the fatigue crack-propagation-induced ε-martensitic transformation to decelerate crack propagation at a total strain range of 2%, obtaining an extraordinary LCF life of 1.1 × 104 cycles.
17 August 2018 in Journal of Micromechanics and Microengineering
The micro-nozzle is an important component of the micropropulsion system for accelerating the gas flow. However, the 3D ceramic micro-nozzle is difficult to machine due to its small complex structure and high hardness of material. In this study, micro-electrical discharge machining (EDM) segmented milling is proposed to fabricate the ZrB 2 –SiC–graphite ceramic micro-nozzle. To improve the machining efficiency and reduce the electrode wear, the micro-nozzle is machined using two tool electrodes with different diameters. The inlet and outlet segments of micro-nozzle are machined by the large diameter electrode, and the throat segments are fabricated with the small diameter electrode. The effects of layer thickness, tool electrode feedrate and electrode diameter on machining performances are investigated in preliminary experiments, and the proper machining parameters are determined. The processing tool-path is planned for producing the micro-nozzle with consideration of the dimension error induced by the machining gap. The micro-nozzle with the conical convergent section and parabolic divergent section is successfully machined, exhibiting high processing efficiency and machining accuracy. It is demonstrated that the proposed micro-EDM segmented milling method is feasible for fabricating the ZrB 2 –SiC–graphite ceramic micro-nozzle.
1 September 2019 in Materials Research Express
We have studied the mechanical properties of black phosphorene (black P) and blue phosphorene (blue P) at different temperatures using molecular dynamic simulations. It is obviously found that the blue P has isotropic mechanical properties, comparing with the anisotropy of black P. This different properties between the two phosphorene allotropes results from their different structures. The calculation has demonstrated temperature has weak effect on the Young's moduli of black and blue P. In contrast, for the black and blue P, the values of fracture stress decrease linearly as the temperature increases. On the whole, the reduction of the fracture strain is rapid at lower temperature region. Our simulation results are in qualitative agreement with the previous theoretical calculations.