1 September 2006 in Postharvest Biology and Technology
8 February 2012 in Journal of the Science of Food and Agriculture
1 September 2004 in Journal of Food Engineering
1 December 2002 in Journal of Food Engineering
1 January 2011 in Procedia Food Science
Intact starch granules are a new source of particles for stabilizing emulsions, so called Pickering emulsions. Small (1-2μm) and uni-modal starch granules at various concentrations have been used in this study to investigate the stability of the emulsions, the drop size dependence of the starch concentration and the barrier properties of the stabilizing starch layer upon heating. The granules were modified with octenyl succinic anhydride (OSA) to increase the hydrophobicity. The drops in the emulsions prepared in this study were in the 10-100μm range depending on the starch concentration, and the drop size decreased with an increased amount of added starch granules. During the 8 week storage, the emulsion drops were stable to coalescence and the volume occluded by the emulsion phase was unaffected or even increased. In order to increase the barrier properties at the oil-water interface the emulsions were gently heated, which induced a partial gelatinization of the starch granules. The efficiency of the barrier was characterized by a lipolysis experiment where the activity of lipase was measured. The activity of lipase was decreased with nearly 70% compared to an unheated starch stabilized emulsion, which will be useful in applications where a controlled release of specific substances in the gastro intestinal tract is desirable
3 August 2012 in Faraday Discussions
Intact starch granules isolated from quinoa (Chenopodium quinoa Willd.) were used to stabilize emulsion drops in so-called Pickering emulsions. Miglyol 812 was used as dispersed phase and a phosphate buffer (pH7) with different salt (NaCl) concentrations was used as the continuous phase. The starch granules were hydrophobically modified to different degrees by octenyl succinic anhydride (OSA) or by dry heat treatment at 120 °C in order to study the effect on the resulting emulsion drop size. The degree of OSA-modification had a low to moderate impact on drop size. The highest level of modification (4.66%) showed the largest mean drop size, and lowest amount of free starch, which could be an effect of a higher degree of aggregation of the starch granules and, thereby, also the emulsion drops stabilized by them. The heat treated starch granules had a poor stabilizing ability and only the starch heated for the longest time (150 min at 120 °C) had a better emulsifying capacity than the un-modified native starch granules. The effect of salt concentration was rather limited. However, an increased concentration of salt slightly increased the mean drop size and the elastic modulus.