7 September 2020 in Nature Geoscience
12 January 2018 in Geophysical Research Letters
The evolution of permeability on fractures and faults during the full earthquake cycle is shown to be sensitive to sealing during the repose phase. We explore the combined effect of static loading followed by fracture reactivation on permeability evolution via slide-hold-slide experiments. During the hold periods, permeability exhibits a slow but continuous reduction. The permeability decay is consistent with power law compaction of the aperture coupled with cubic law flow. With increasing hold periods, permeability evolves following reactivation from net reduction to net increase with the magnitude of the permeability change dependent on the hold period. This implies that the tight interlocking of asperities during inter-seismic repose primes the fault for permeability enhancement following reactivation. The inferred mechanism is via shear dilation with the probable involvement of unclogging. This result identifies that pre-slip sealing during repose is an essential component in the cyclic permeability evolution throughout the seismic cycle.
8 December 2017 in Journal of Geophysical Research: Solid Earth
Interseismic frictional healing is an essential process in the seismic cycle. Observations of both natural and laboratory earthquakes demonstrate that the magnitude of stress drop scales with the logarithm of recurrence time, which is a cornerstone of the rate and state friction (RSF) laws. However, the origin of this log linear behavior and short time “cutoff” for small recurrence intervals remains poorly understood. Here we use RSF laws to demonstrate that the back‐projected time of null‐healing intrinsically scales with the initial frictional state θi. We explore this behavior and its implications for (1) the short‐term cutoff time of frictional healing and (2) the connection between healing rates derived from stick‐slip sliding versus slide‐hold‐slide tests. We use a novel, continuous solution of RSF for a one‐dimensional spring‐slider system with inertia. The numerical solution continuously traces frictional state evolution (and healing) and shows that stick‐slip cutoff time also scales with frictional state at the conclusion of the dynamic slip process θi (=Dc/Vpeak). This numerical investigation on the origins of stick‐slip response is verified by comparing laboratory data for a range of peak slip velocities. Slower slip motions yield lesser magnitude of friction drop at a given time due to higher frictional state at the end of each slip event. Our results provide insight on the origin of log linear stick‐slip evolution and suggest an approach to estimating the critical slip distance on faults that exhibit gradual accelerations, such as for slow earthquakes.
13 May 2019 in Journal of Geophysical Research: Solid Earth
Cyclic growth and decay of permeability in fractures is explored during repeated reactivation and repose of saw‐cut fractures of Green River shale. These slide‐hold‐slide experiments are supported by measurements of fracture normal deformation and optical surface profilometry. Overall, we observe continuous permeability decay during repose (holds) and significant permeability enhancement during slow reactivation (slide). The permeability decay is accompanied by fault compaction. Both hydraulic aperture change (Δbh) and measured compaction (Δbs) are consistent with time‐dependent power law closure with a power exponent of ~0.2–0.4. These dual compaction magnitudes are positively correlated but Δbh > Δbs in late stage holds. Permeability enhancement during reactivation is typically also accompanied by fault dilation. However, we also observe some cases where hydraulic aperture change decouples from the measured deformation, conceivably driven by mobilization of wear products and influenced by the development of flow bottlenecks. Pretest and posttest surface profiles show that the surface topography of the fractures is planed down by shear removal. The shear removal is significant with initial laboratory prepared surface (~10 μm of aperture height) but less significant following consecutive reactivations (~2 μm). The flattened surfaces retain small‐scale, ~10–20 μm wavelength, roughness. Flow simulations, constrained by the surface topography and measured deformation, indicate that small‐scale roughness may control permeability at flow bottlenecks within a dominant flow channel. These results suggest cycles of permeability creation and destruction are an intrinsic component of the natural hydraulic system present in faults and fractures and provide an improved mechanistic understanding of the evolution of permeability during fault repose and reactivation.