13 September 1999 in Physical Review Letters
The radial profile of Reynolds stress has been measured in the plasma boundary region of the ISTTOK tokamak using a multiarray of Langmuir probes. The electrostatic Reynolds stress component, proportional to the cross correlation of radial and poloidal fluctuating electric fields, shows a radial gradient close to the velocity shear layer location. It is shown that this mechanism may drive significant poloidal flows in the plasma boundary region.
1 May 2000 in Plasma Physics and Controlled Fusion
A view of the latest experimental results and progress in the understanding of the role of poloidal flows driven by fluctuations via Reynolds stress is given. Reynolds stress shows a radial gradient close to the velocity shear layer location in tokamaks and stellarators, indicating that this mechanism may drive significant poloidal flows in the plasma boundary. Observation of the generation of E×B sheared flows via Reynolds stress at the ion Bernstein resonance layer has been noticed in toroidal magnetized plasmas. The experimental evidence of sheared E×B flows linked to the location of rational surfaces in stellarator plasmas might be interpreted in terms of Reynolds stress sheared driven flows. These results show that E×B sheared flows driven by fluctuations can play an important role in the generation of transport barriers.
1 October 2006 in Review of Scientific Instruments
The efficient vertical stabilization (VS) of plasmas in tokamaks requires a fast reaction of the VS controller, for example, after detection of edge localized modes (ELM). For controlling the effects of very large ELMs a new digital control hardware, based on the Advanced Telecommunications Computing Architecture™ (ATCA), is being developed aiming to reduce the VS digital control loop cycle (down to an optimal value of ) and improve the algorithm performance. The system has 1 ATCA™ processor module and up to 12 ATCA™ control modules, each one with 32 analog input channels ( resolution), 4 analog output channels ( resolution), and 8 digital input/output channels. The Aurora™ and PCI Express™ communication protocols will be used for data transport, between modules, with expected latencies below . Control algorithms are implemented on a ix86 based processor with and on field programmable gate arrays with , interconnected by serial gigabit links in a full mesh topology.
1 January 2001 in Review of Scientific Instruments
An advanced 200 keV heavy ion beam diagnostic has been developed for the TJ-II stellarator based on the simultaneous utilization of a 30° Proca–Green electrostatic energy analyzer and a multiple cell array detector. This innovative design allows instantaneous measurements of plasma potential and electron density profiles together with their respective fluctuations. In this article we present a description of the main parts of a heavy ion beam diagnostic (injection system, detectors, and control and data acquisition system) and the results obtained during the first operation on TJ-II. The problems of plasma loading of the detectors and hard x-ray generation associated with the probing beam are reported.
1 March 2003 in Review of Scientific Instruments
The plasma potential Φ pl and its fluctuations Φ̃ pl were measured by electron emissive probes in the edge plasma regions of two fusion experiments: the Instituto Superior Técnico Tokamak (ISTTOK) (Lisbon, Portugal), and the Czech Academy of Sciences Torus (CASTOR) tokamak (Prague, Czech Republic). Into ISTTOK, three emissive probes were inserted outside the last closed flux surface (LCFS) on different minor radii. In CASTOR, two emissive probes, poloidally separated, and two cold cylindrical probes, mounted on the same shaft, were used, which could be radially shifted outside and inside the LCFS. The advantages of a sufficiently emissive probe are that in principle Φ pl and Φ̃ pl can be measured directly, without being affected by electron temperature fluctuations or drifting electrons.
1 January 1996 in Fusion Technology
The first Portuguese magnetic confinement experiment, the tokamak ISTTOK, has been in operation since 1993. This tokamak device is described and the main technological features, as well as the novel techniques of its diagnostics and control and data acquisition system, are reported. A synopsis of the experimental activity is also presented.