1 January 2018 in Advances in Civil Engineering
In order to reveal the failure mechanism of the deep roadway under mining‐induced pressure in coal mine, the boundary equations for the plastic zone around the deep roadway were deduced, and then the evolution laws for morphology of the plastic zone and the relationship between the morphological indexes and the stability of surrounding rock were discussed. The results show that, for the deep roadway, the effect of mining on the plastic zone is more sensitive than that on the shallow one. Even if the changes of mining influence are small, they may also cause extremely serious plastic failure of surrounding rock masses, leading to the sudden instability of the roadway. When the plastic wings of the plastic zone are approximately perpendicular to the roof, floor, or sidewall, the large deformation and failure of the deep roadway are very likely to occur. Compared with the index of the uniformity coefficient, the irregular shape coefficient can be used to better characterize the differences in the plastic zone morphology. Finally, a case study was provided to apply the principles for the formation and extension of a butterfly‐shaped plastic zone.
1 January 2020 in Advances in Civil Engineering
This paper aims at the phenomenon of the fractured rock column in underground engineering which is prone to collapse when subjected to ground pressure. Uniaxial compression test and particle flow code (PFC2D) are used to analyze the influence of crack dip angle on the mechanical properties, crack propagation, and the failure mode of red sandstone. From the results, it is observed that the stress–strain curve of the precracked red sandstone can be divided into five stages, and there is a critical stress value in the stage of accelerated crack propagation and unstable fracture of the rock sample. Further, the peak strength, maximum strain, and the elastic modulus of the precracked red sandstone increase with the increase of crack dip angle, and the ultimate failure mode of rock sample changes from the “ladder” type failure to slope uneven failure. Furthermore, from PFC2D simulation, it is found that the tensile microcracks contribute more towards the failure of rock samples than the shear cracks. The contact force chain is very weak at the places where the precracks and macroshear planes are formed. This indicates that the original contact force is weakened due to particle fracture. Therefore, the bearing capacity of the precracked rock samples decreases with the increase in load. From the simulation results, it is found that the displacement at the shear plane of the rock sample is large, and the shear dilatation occurs. With the increase in load, the specimen falls off and is ejected. This is due to the weakening of the contact force between the internal particles. Thereafter, it fractures to produce microcracks, which gradually converge, thus providing a prerequisite for the transformation of elastic strain energy into kinetic energy.
1 May 2019 in IOP Conference Series: Earth and Environmental Science
In order to solve the problem of instability discrimination for water-rich roadway in sandy-gravel stratum, taking the displacement function and damaged area function as potential functions of the roadway surrounding rock system based on catastrophe theory, the instability criterions of the roadway in sandy-gravel stratum under seepage were established, i.e. the criterion for extremal modulus of displacement and criterion for the damaged area. Then the specific process for stability discrimination was further proposed. A PFC2D numerical model for a shaft bottom roadway in a large coal mine in Xinjiang was established. The calculation results show that as seepage pressure increases, modulus of displacement and damaged area in surrounding rock present irregular fluctuations and similar change rule. In the latter stage of the increase of seepage pressure, the deformation and damage of the roadway all have experienced a sharp sudden raise. And the conclusion of instability discrimination obtained from the calculation results of catastrophic eigenvalues for modulus of displacement and damaged area are consistent with damage evolution and instability process of the surrounding rock, which verifies the feasibility and applicability of the instability criterions.
23 February 2019 in IOP Conference Series: Earth and Environmental Science
In order to solve the problem of discriminant criterion for deep roadway instability, the core of surrounding rock failure in deep roadway and its two types of instability mechanisms were analysed. Based on the cusp catastrophe model and taking the plastic radius function as the potential function of the roadway system, the instability discriminant of surrounding rock was derived and the catastrophic criterion for instability of deep roadway under the influence of disturbance was established. Aiming at the engineering application of this criterion, the implementation method and detailed procedure of stability discrimination for the deep roadway were proposed. The numerical results show that the malignant expansion of plastic zone often occurs in surrounding rock causing large deformation or transient instability in the ultra-high deviatoric stress environment. Under the influence of external disturbance, the plastic radius experienced two stages including slow increase and nonlinear acceleration. The discriminant conclusion of the deep roadway instability according to the calculation results of the catastrophic eigenvalues is consistent with the extension of the plastic zone during the instability process of surrounding rocks, which verifies that the established instability criterion is feasible and applicable.
23 February 2019 in IOP Conference Series: Earth and Environmental Science
Aiming at instability of rock pillar subjected to dynamic load in underground mining, damage and failure process of rock with double-fractures under uniaxial dynamic compression was simulated by particle flow code (PFC). Mesoscopic damage variable was defined based on the number of fracture bonds between particles, and damage characteristics of the rock with double-fractures was analysed. Then change laws of rock peak strength, cracks distribution, accumulation and release of elastic strain energy were revealed, furthermore the internal cause for accelerated growth of rock sample microcracks post peak was obtained. The results show that the number of cracks on rock with double-fractures increases with the peak strength under uniaxial dynamic compression. Compared with large-size fractures, the rock sample with small-size fractures takes longer to reach peak strength and have higher bearing capacity. Additionally the number of microcracks on the rock sample is positively correlated with the mesoscopic damage variable (D), while the elastic strain energy accumulated at the peak and the peak strength are all negatively correlated with the length of fracture B.