10 December 2019 in Scientific Reports
Detection of visible blind UV radiation is not only interesting but also of technologically important. Herein, we demonstrate the efficient detection of UV radiation by using cluster like ZnS quantum dot solid nanostructures prepared by simple reflux condensation technique. The short-chain ligand 3-mercaptopropionic acid (MPA) involved in the synthesis lead to the cluster like formation of ZnS quantum dots into solids upon prolonged synthesis conditions. The ZnS QD solid formation resulted in the strong delocalization of electronic wave function between the neighboring quantum dots. It increases the photocurrent value, which can be further confirmed by the decrease in the average lifetime values from 64 to 4.6 ns upon ZnS cluster like QD solid formation from ZnS QDs. The ZnS quantum dot solid based UV sensor shows good photocurrent response and a maximum responsivity of 0.31 (A/W) at a wavelength of 390 nm, is not only competitive when compared with previous reports but also better than ZnS and metal oxide-based photodetectors. The device exhibits a high current value under low-intensity UV light source and an on/off ratio of IUV/Idark = 413 at zero biasing voltage with a fast response. Further, photocurrent device has been constructed using ZnS quantum dot solid nanostructures with graphene hybrids as an active layer to improve the enhancement of photoresponsivity.
18 August 2020 in ACS Applied Nano Materials
26 June 2024 in Materials Advances
Bi-doped CsPbBr3 photodetector device response with X-ray and gamma-ray detection and visible range photodetection.
14 September 2021 in ACS Applied Nano Materials
21 May 2023 in New Journal of Chemistry
Dumbbell-like silver bismuth iodide perovskite heterostructures were fabricated via the growth of heterogeneous silver using a modified emulsion method. Owing to the immiscibility between DMF and hexane, the silver bismuth iodide precursors in DMF could be dispersed as microscopic droplets in hexane under vigorous stirring. Subsequently, the addition of acetone as a demulsifier provided the driving force for crystallization to form dumbbell-shaped silver bismuth iodide perovskite heterostructures. In this synthesis, we added a high concentration of Ag precursors to DMF, which influenced the morphology changes to form a silver-metal-head dumbbell-shaped silver bismuth iodide perovskite hybrid system. However, in the dumbbell heterostructure, a large silver domain was exclusively grown on a single side of the AgBi2I7 system. Further, the as-prepared dumbbell-shaped AgBi2I7 heterostructure sample was used to fabricate a photo-sensitive device and its time-dependent photocurrent properties were analysed. The dumbbell-shaped metal-perovskite heterostructure sample exhibited a higher photocurrent magnitude of ∼21 and 70 μA for 0.1 and 0.2 V bias voltage, with a high ON–OFF ratio of 3.1 × 104 and 3.2 × 104, respectively. The improved photocurrent indicates that the transfer of photogenerated electrons was facilitated from the perovskite system to the metal head.