20 March 2025 in Proceedings of the Institution of Mechanical Engineers, Part F: Journal of Rail and Rapid Transit
Inerters are widely used in structural vibration systems, but there is little research on their use in the elastic-suspension of motors in high-speed train bogies. The type of the motor suspension significantly influences its vibration characteristics. To fill this gap, this paper proposes the use of the frequency-variable characteristics of the inertia spring damping (ISD) structure. The motor elastic-suspension bogie dynamic model with the inerter was established, and the effect of the motor suspension parameters on the stability of the bogie system was studied. Finally, the inertia-suspension parameters were optimized by the Non-dominated Sorting Genetic Algorithm-Ⅱ (NSGA-Ⅱ) multi-objective optimization algorithm. The results showed that the ISD structure has frequency-varying characteristics, and the maximum equivalent stiffness and damping exist in the low frequency range (approximately 10 Hz). As the equivalent conicity increases, the optimal lateral frequency and damping ratio of the motor increase, which makes the inerter suspension bogie to meet this characteristic. The optimized motor suspension parameters showed that the linear critical speeds of the bogie with inerter suspension are improved, and the stability of the bogie is higher within the equivalent conicity of 0.1-0.4. This study can provide a reference for the stability design of the bogie structure in future.
19 May 2020 in Journal of Micromechanics and Microengineering
The combustion of a micro-piston internal combustion engine with platinum wire glow ignition is diagnosed. The results show that the combustion starting point of the micro piston internal combustion engine varies greatly, and the combustion duration is various and long. The coefficient of variation of p max is as high as 28.5%, the combustion stability is poor. Therefore, it is suggested to improve the thermal environment in the cylinder to improve the combustion stability. One method is to increase the temperature in the cylinder to reduce the duration and the cyclic variation of combustion. The other method is to increase the temperature of the platinum wire to improve the stability of the starting point of combustion and to reduce the cyclic variation of combustion. The test results show that with the increase in the cylinder body temperature, the distribution of combustion starting point is more concentrated, and the coefficient of variation of p max decreases by about 38.6%. The stability of combustion increases. So the combustion stability can be improved by appropriately increasing the temperature of cylinder body. With the increase temperature of the platinum wire, the ignition and combustion will be facilitated and the combustion stability will be improved. At the same time, the movement of the gas near the platinum wire will be accelerated, which gives rise to affect the flame-kernel development and flame propagation. The ignition points will become scattered, which increases the instability of combustion.
10 March 2020 in Diagnostyka
Constrained by the micro-space structure, it is proposed to use platinum wire incandescent ignition combustion mode to achieve the operation of internal combustion engine. However, the combustion test of the platinum wire incandescent ignition in miniature piston internal combustion engine shows:...