College of Chemical Engineering Co‐Innovation Center for Efficient Processing and Utilization of Forest Products Nanjing Forestry University Nanjing Jiangsu 210037 People's Republic of China
Auto-generated profile, based on publicly available information
Xiaobao Li
College of Chemical Engineering Co‐Innovation Center for Efficient Processing and Utilization of Forest Products Nanjing Forestry University Nanjing Jiangsu 210037 People's Republic of China
The typical platinum nanoparticles loaded on titania (Pt/TiO2) were pretreated with mild oxidation (<300 °C) in pure oxygen to enhance the low-temperature formaldehyde (HCHO) decomposition performance. The structural properties of support and platinum nanoparticles were characterized by X-ray diffraction (XRD), physical adsorption/desorption, high-resolution transmission electron microscopy (HRTEM), in situ diffuse reflectance infrared Fourier transform spectroscopy (DRIFITS), and temperature-programmed reduction and oxidation (TPR and TPO). The catalytic results showed that the low temperature HCHO decomposition activity of mild pre-oxidized Pt/TiO2 was around three times that of the pristine one. According to the characterization results, the structure of the Pt/TiO2 support and their Pt particle sizes had negligible change after pre-oxidation treatment. The cationic Pt content of Pt/TiO2 and surface roughness of Pt nanoparticles gradually increased with the increasing temperature of the pre-oxidation treatment. Mild pre-oxidation treatment was beneficial to the oxygen activation and water dissociation of Pt/TiO2. In situ HCHO-DFIRTS results showed that the mild pre-oxidation treatment could enhance the dehydrogenation of formate.
A green and facile preparation was used to synthesize modified lignin (ML) from alkaline lignin by using hexamethylene diisocyanate (HDI) as the modifier and tetrahydrofuran as the solvent without a catalyst. Then, the as-synthesized ML was dispersed in hydroxy acrylic resin and used to prepare modified lignin-based polyurethane composites by using HDI trimer as the curing agent and dibutyltin dilauric acid as the catalyst at room temperature. Fourier transform infrared (FTIR) and elemental analysis confirmed that the main chemical in ML was lignin urethane when the amount of HDI was 0.2 g. The tensile strength of the modified lignin-based polyurethane (MLPU-0.2) film using ML-0.2 reached 12.07 MPa, which was improved by 23.2% and 68.3% compared with that of the pure polyurethane (PU) film (9.79 MPa) and lignin-based polyurethane (LPU) film prepared using unmodified lignin (7.17 MPa), respectively. After the addition of lignin or ML, the elongation at break of the polyurethane film increased. The water contact angle of MLPU-0.2 increased up to 96°, which was higher than that of PU (74°) and LPU (68°). The pencil hardness of MLPU-0.2 (3 H) was higher than that of PU (H) and LPU (2 H). Modified lignin-based polyurethane shows promise for marine anticorrosive coatings.