3 April 2012 in Journal of Materials Chemistry
A new spectroscopic tool for the quantitative evaluation of dye-sensitizer uptake into TiO2 semiconductor films for application in DSCs is presented, here applied to N719 dye and TiO2-dye dipping times spanning from a few seconds up to 24 h. By the integration of the whole absorption spectrum in the Vis range or of the most significant low-energy peak, a conversion table could be built to be used as a reliable tool for evaluating the amount of adsorbed dye from the spectral response of the dye-coated films, independently of any spectral modification of the response with dipping time (indeed observed). In particular for N719 under the investigated conditions, we have demonstrated that the first hour is strategic for an effective uptake of the dye by the TiO2 nanoparticles, with a saturation level reached within the first 5 h, suggesting that commonly used longer dipping times, typically 16–24 h, are useless or even undesirable when making DSC devices. In addition, we have found that the whole adsorption process, from few seconds up to 24 h dipping time, is very nicely described by a simple pseudo-first order kinetic model, in contrast with previous findings, with an observed rate constant of 3.1 × 10−4 s−1.
16 April 2008 in The Journal of Chemical Physics
The full UV-visible dielectric tensor and the corresponding directions of the principal axes of triclinic tetracene crystals are reported as deduced either by polarized absorption and ellipsometry measurements or by calculations based on the molecular and crystallographic data. The results allow the attribution of the polarized bands observed in both absorption and photoluminescence emission spectra. In particular, the spectral line shape and polarization of the emission are found to depend on the sample thickness, and the effect is attributed to the modification of the state of polarization of the emitted light during its propagation inside the crystal. Indeed, the directions of polarization of the lowest optical transitions and the directions of the principal axes of the dielectric tensor are demonstrated not to coincide, in contrast to the assumptions typically made in the literature, thus causing the mixed transverse/longitudinal character of light propagation.
18 September 2013 in Advanced Functional Materials
12 November 2007 in The Journal of Chemical Physics
Exciton-phonon (EP) coupling in molecular aggregates is reexamined in cases where extended intermolecular interactions result in low-energy excitons with high effective masses. The analysis is based on a single intramolecular vibrational mode with frequency ω0 and Huang-Rhys factor λ2. When the curvature Jc at the exciton band bottom is much smaller than the free-exciton Davydov splitting W, the strength of the EP coupling is determined by comparing the nuclear relaxation energy λ2ω0 with the curvature. In this way, weak (λ2ω0⪡4πJc), intermediate I (λ2ω0≈4πJc), and strong I (λ2ω0⪢4πJc) coupling regimes are introduced. The conventional intermediate (λ2ω0≈W) and strong (λ2ω0⪢W) EP coupling regimes originally defined by Simpson and Peterson [J. Chem. Phys. 26, 588 (1957)] are based solely on the Davydov splitting and are referred to here as intermediate II and strong II regimes, respectively. Within the intermediate I and strong I regimes the near degeneracy of the low-energy excitons allows efficient nonadiabatic coupling, resulting in a spectral splitting between the b- and ac-polarized first replicas in the vibronic progression characterizing optical absorption. Such spectral signatures are clearly observed in OT4 thin films and crystals, where splittings for the lowest energy mode with ω0=161cm−1 are as large as 30cm−1 with a small variation due to sample disorder. Numerical calculations using a multiphonon BO basis set and a Hamiltonian including linear EP coupling yield excellent agreement with experiment.
30 September 2009 in Chemistry of Materials
27 August 2009 in The Journal of Physical Chemistry C