A porous structure is an important characteristic of crisp food and can be produced by a puffing process. However, puffed products may brown during puffing. To limit the browning reaction, food, in particular fruits, needs to be osmotically treated before puffing. This research therefore studied how osmotic treatment affects the quality of a puffed fruit sample, viz. banana. Banana with 20–23° Brix total soluble solid was immersed in sucrose solution concentrations at 30, 35, and 40° Brix and dried at 90°C using hot air until the sample moisture content was reduced to 30% dry basis. Then the banana slices were puffed using superheated steam at 180, 200, and 220°C for 150 s and dried again at 90°C until the sample moisture content reached 4% (db). It was found that osmotic dehydration could improve the color of puffed banana, with less browning than the non-osmotically treated puffed banana because the amounts of glucose and fructose in banana, which serve as important reagents for browning reactions, were decreased. The puffing temperature and osmotic concentrations did not enhance the browning rate. Sucrose impregnation resulted in longer drying times and limited banana cell wall expansion due to the interaction between the hydroxyl group of sucrose and that of banana tissue. This interaction further resulted in significantly higher shrinkage of the osmotically treated sample and a denser structure as viewed by scanning electron microscopy. The morphology of osmotically treated banana was a hard and brittle texture.
A pilot-scale rubberwood dryer was constructed and injected with superheated steam and hot air to study the effect of the hybrid system on the drying rate and mechanical properties of the wood. A total of 300 pieces of rubberwood boards, each with dimensions of 1000 mm long × 76.2 mm wide × 25.4 mm thick, were stacked in 1.0 m × 1.0 m × 1.7 m (1.7 m3) pallet. The stack was impinged with alternating cycles of superheated steam and hot air. The time required for conventional drying was 168 hours, but the drying time for the hybrid system was only 64 hours, resulting in a 62% reduction. After being dried, the rubberwood boards were mechanically tested for static bending, compression strength, hardness, and shear strengths. From the mechanical tests, the hybrid drying system using superheated steam and hot air had no significant effect on the mean shear strength parallel-to-grain; however; the mean compression strength parallel-to-grain was reduced by 24.2% and the mean MOR by 21.4%. Nonetheless, the mean MOE was increased by 30.4% and the mean of hardness by 16.4%.
11 November 2021 in Journal of Food Process Engineering