29 September 2011 in Journal of Lightwave Technology
We demonstrate a self-seeded multicasting device capable of delivering a large number of signal integrity preserving spectrally-distinct copies. The new multicasting device relies on efficient higher-order mixing in a two-pump parametric mixer. Precise dispersion engineering was deployed to generate a frequency-comb spanning over a 140-nm band, and resulted in the creation of more than 60 spectral copies of the signal with conversion efficiencies higher than -3 dB. The fidelity of the multicasting device with respect to signal intensity and phase was characterized experimentally. The spectral replication process was found to induce low penalty with both ON-OFF and differential phase-shift keying signals, thereby indicating compatibility with arbitrary amplitude/phase signaling formats.
25 April 2014 in Journal of Lightwave Technology
An essential capability in many applications, ranging from commercial, surveillance and defense, is to analyze the spectral content of intercepted microwave and millimeter-wave signals over a very wide bandwidth in real-time and with high resolution. A range of photonic schemes have been introduced for the real-time processing of wideband signals to overcome limitations of current conventional electronic frequency measurement approaches. Here, a novel microwave/millimeter-wave channelizer is presented based on a RF photonic front-end employing parametric wavelength multicasting and comb generation. This new technology enables a contiguous bank of channelized coherent I/Q IF signals covering extremely wide RF instantaneous bandwidth. High channel counts and wide RF instantaneous bandwidth are enabled by use of parametrically generated frequency-locked optical combs spanning >4 THz. Full field analysis capabilities of the coherent detection system are demonstrated by frequency domain analysis of 18 contiguous 1.2 GHz IF channels covering 15.5 GHz to 37.1 GHz input frequency range, and time and spectral domain analysis of a 75 GHz harmonically generated input signal. Sensitivity and dynamic range of the system are analyzed and discussed.
11 December 2015 in Science
Detecting a transient needle in a haystack: Discriminating signals within a noisy environment is an issue crucial to many disciplines, from observational astronomy to secure communication and imaging. If the signal is periodic, then averaging over many measurements can help enhance the signal-to-noise ratio. However, for signals that present as a single transient event, the detection capability has been limited. Ataie et al. developed a detector that can lift that limitation by combining signal cloning with frequency combs and signal-processing techniques (see the Perspective by Vasilyev). Their detector could detect signals buried within noise that would otherwise be undetectable. Science , this issue p. 1343 ; see also p. 1314
3 December 2008 in Laser & Photonics Reviews
23 June 2020 in Journal of Lightwave Technology
In this paper, we design and demonstrate new angled multimode interference (MMI) couplers in silicon-on-insulator that allow arbitrary selection of coupling ratios, while simultaneously achieve low-chromaticity response and improved fabrication variations tolerance. The proposed couplers rely on paired-interference design approach in tandem with a new angled multi-mode junction to mitigate chromatic aberration and geometry-induced waveguide modal shift in conventional angled MMI coupler design. Test devices with footprint of 4.8 μm x 75 μm showed full coupling ratio range addressability with insertion loss below 1.2 dB. Spectral responses across the extended C band (1525 nm — 1575 nm) were also characterized, where coupling ratio varied by less than 2.3% across the spectral region of interest. Furthermore, coupler characteristics variations against line-width and thickness deviations are numerically analyzed, demonstrating robustness within typical fabrication tolerances.
26 March 2007 in Journal of Lightwave Technology
Wavelength conversion based on degenerate four-wave mixing in a photonic crystal fiber with two zero-dispersion wavelengths is investigated both theoretically and experimentally. The proposed concept of universal band translation in a single-pass traveling-wave structure offers a wavelength band rather than a single-wavelength mapping between distant spectral ranges. Near-infrared signals are modulated using both harmonic and pseudorandom bit sequences and translated to the visible optical band. Multiple-channel translation, which produces wavelength-division-multiplexed idlers in the visible band, is demonstrated for the first time. The performance of the translation process is measured both spectrally and temporally for both single- and multiple-channel signals