We report, to the best of our knowledge, the first fully referenced Cr:ZnS optical frequency comb. The comb features few cycle output pulses with 3.25 W average power at 80 MHz repetition rate, spectrum spanning 60 THz in the middle-IR range 1.79–2.86 µm, and a small footprint (0.1 m2), The spectral components used for the measurement of the comb’s carrier envelope offset frequency were obtained directly inside the polycrystalline Cr:ZnS laser medium via intrinsic nonlinear interferometry. Using this scheme we stabilized the offset frequency of the comb with the residual phase noise of 75 mrads.
Using sub-3-cycle pulses from mode-locked Cr:ZnS lasers at λ ≈ 2.4 µm as a driving source, we performed high-resolution dual-frequency-comb spectroscopy in the longwave infrared (LWIR) range. A duo of highly coherent broadband (6.6–11.4 µm) frequency combs were produced via intrapulse difference frequency generation in zinc germanium phosphide (ZGP) crystals. Fast (up to 0.1 s per spectrum) acquisition of 240,000 comb-mode-resolved data points, spaced by 80 MHz and referenced to a Rb clock, was demonstrated, resulting in metrology grade molecular spectra of N2O (nitrous oxide) and CH3OH (methane). The key to high-speed massive spectral data acquisition was low intensity and phase noise of the LWIR combs and high (7.5%) downconversion efficiency, resulting in a LWIR power of 300 mW for each comb.
We report a few-cycle, super-octave, polycrystalline Cr:ZnS laser system with 4 W power at 78 MHz repetition rate, where all of the necessary optical signals for the measurement of the carrier–envelope offset frequency are generated intrinsically.
We report, to the best of our knowledge, the first super-octave femtosecond polycrystalline Cr:ZnS laser at the central wavelength 2.4 µm. The laser is based on a non-polarizing astigmatic X-folded resonator with normal incidence mounting of the gain element. The chromatic dispersion of the resonator is controlled with a set of dispersive mirrors within one third of an optical octave over 2.05–2.6 µm range. The resonator’s optics is highly reflective in the range 1.8–2.9 µm. The components of the oscillator’s output spectrum at the wavelengths 1.6 µm and 3.2 µm are detected at –60 dB with respect to the main peak. Average power of few-cycle Kerr-lens mode-locked laser is 1.4 W at the pulse repetition frequency 79 MHz. That corresponds to 22% conversion of cw radiation of Er-doped fiber laser, which we used for optical pumping of the Cr:ZnS oscillator.
We report a technique for generation of broad and coherent femtosecond (fs) continua that span several octaves from visible to long-wave IR parts of the spectrum (0.4–18 µm). The approach is based on simultaneous amplification of few-cycle pulses at 2.5 µm central wavelength at 80 MHz repetition rate, and augmentation of their spectrum via three-wave mixing in a tandem arrangement of polycrystalline Cr:ZnS and single crystal GaSe. The obtained average power levels include several mW in the 0.4–0.8 µm visible, 0.23 W in the 0.8–2 µm near-IR, up to 4 W in the 2–3 µm IR, and about 17 mW in the 3–18 µm long-wave IR bands, respectively. High brightness and mutual coherence of all parts of the continuum was confirmed by direct detections of the carrier envelope offset frequency of the master oscillator.
21 April 2021 in Journal of the Optical Society of America B
Until recently, the generation of super-octave continua in bulk materials at full repetition rates of femtosecond (fs) oscillators has been limited to a few special cases of Kerr lens mode-locked Ti:sapphire lasers. In 2019, we described a 3.4-octave fs source with 50 nJ pulse energy at the repetition rate of 78 MHz based on polycrystalline Cr:ZnS [Vasilyev et al., Optica 6, 126 (2019)OPTIC8 2334-2536 10.1364/OPTICA.6.000126 ]. Here we explain the mechanism of fs supercontinuum generation in transition-metal doped polycrystalline II-VI semiconductors at relatively low (nJ-level) pulse energy. We demonstrate that this new supercontinuum regime is enabled by a complex, yet well-reproducible, interplay between the effects arising from the third-order nonlinearity, the quadratic nonlinearities, and thermal optical effects in the medium. We also demonstrate the control of fs pulse propagation in disordered media via the control of the material microstructure.