A dual-loop LC-voltage-controlled oscillator (VCO)-based frequency synthesizer, composed of an all-digital frequency-locked loop (ADFLL) and a voltage-mode, type-I, sub-sampling phase-locked loop (SS-PLL), is presented. A compact SS phase detector is described which also acts as a loop filter (LF). Fabricated in a 65-nm CMOS process, the synthesizer occupies a small footprint of 100 x 100 μm², thanks to its compact LF and full integration underneath the VCO inductor. The synthesizer achieves the sub-200 fs of rms integrated jitter across its tuning range of 4.6-5.6 GHz while consuming no more than 1.1 mW of power. A peak figure-of-merit (FOM) of -255 dB at 5 GHz and an FOM of -254 dB across the tuning range are achieved. A reference spur of -64.1 dBc is measured with the PLL operating at 5 GHz.
6 May 2019 in IEEE Transactions on Circuits and Systems I: Regular Papers
Avalanche photodetectors (APDs) improve the sensitivity of optoelectronic (O/E) receivers (RXs) due to their high multiplication gain and responsivity. When implemented monolithically with a CMOS transimpedance amplifier (TIA) on the same chip, they provide further advantages, such as low cost and reduced parasitics. However, APDs require high bias voltages, are sensitive to variations in operating conditions, and have a limited gain-bandwidth product. This paper presents an 850 nm APD implemented in a standard 0.13-μm CMOS process with a responsivity of 3.92 A/W and a large-signal -3 dB bandwidth of 3.5 GHz. Advantages of on-chip integration with a TIA are described and a noise-canceling active balun following the single-ended TIA is presented. The O/E-RXs front-end achieves a measured sensitivity of -18.8 dBm, the best-reported among 10 Gb/s linear CMOS TIAs operating at 850 nm. The energy/bit is 0.57 pJ/b. An on-chip voltage booster is described and implemented to generate a large APD bias using nominal CMOS voltage supplies. A modified hill-climbing algorithm is also presented that can enable bias stabilization for the voltage booster and the optoelectronic front-end for a complete all-bulk-CMOS implementation.
1 September 2022 in IEEE Journal of Solid-State Circuits
We present a radio frequency self-interference (SI) canceller chip for low-power wide area network (LPWAN) basestations. To enhance the cancellation capability without necessitating unreasonable resolution, power consumption, and area, we introduce a hierarchical cancellation technique using a nested vector modulator (VM) implementation. Nesting a 7-b and two 6-b stages, a 16-b theoretical and $>$ 13-b measured resolution is obtained per tap. LPWAN channels have large group delay and group delay spread in tens of ns, and a requirement for $>$ 100 dB of analog SI cancellation. To enable large on-chip group delay, we leverage frequency translation circuits, and in comparison to prior art, decouple impedance matching requirement from tap delay implementation to realize range/resolution from 16 ns/33 ps to 80 ns/150 ps. We demonstrate 64 dB of RF SI cancellation over 0.8-MHz bandwidth (BW) with a three-tap implementation for an LPWAN wireless channel. For more controlled environments, up to 70-dB cancellation is shown. Each tap occupies 0.21 mm $^2$ of area and consumes 12.3 mA of current with a 1.2-V supply voltage. The whole chip occupies 1.2 mm $^2$ and consumes 44.28 mW of power in a 65-nm CMOS process.
1 January 2019 in IEEE Transactions on Circuits and Systems I: Regular Papers
Despite their inherent stability, area-efficient loop filters, and insensitivity to phase-frequency detector nonlinearity and dead-zone, type-I phase-locked loops (PLLs) are used infrequently because of two major limitations--limited lock-range and large reference spurs. This paper introduces a type-I PLL that takes advantage of the inherent benefits of the architecture, while tackling its limitations by means of gain boosting in the forward path for lock-range improvement and synchronous peak tracking of the voltage-controlled oscillator control voltage for reference spur reduction. Sampling in the loop filter changes the loop dynamics, and methods to accurately predict the closed-loop response, starting from state-space equations, are provided. A digital-friendly, voltage-mode topology is proposed that does not need charge pumps or opamps. A prototype 2.2-2.8-GHz PLL occupies a core area of 0.12 mm² in 0.13-μm CMOS and achieves -103.4 dBc/Hz in-band phase noise, -65-dBc reference spur, and 2.5-μs worst-case lock-time while consuming 6.8 mW from a 1.2-V supply.
26 May 2023 in IEEE Journal of Solid-State Circuits
A serrodyne modulator (SM)-based fractional frequency synthesizer is presented. The SM receives its input signal with large deterministic jitter (DJ) from a multiplexer (MUX)-based fractional divider, and by employing linear sawtooth modulation of delay, attenuates the DJ, achieving low-noise fractional frequency synthesis. With a small footprint (0.01 mm $^{2}$ in 65-nm CMOS), it is ideal for multi-output clock generation, fast frequency switching, and spread-spectrum clocking (SSC). With an on-chip phase-locked-loop (PLL)-generated 5 GHz signal as input, and a 2.4899 GHz output, the circuit achieves $\ge$ 7.2 $\times$ reduction in the peak-to-peak DJ (DJ $_{\mathrm{PP}})$ . With an external 8.7 GHz input, and a 4.33 GHz output, DJ $_{\mathrm{PP}}$ reduction is $\ge$ 6.2 $\times$ . We also present a dynamic clocked-CMOS (C $^{2}$ MOS) quadrature divider to realize a low-power and low-jitter operation.