Samuli Saarelma

Samuli Saarelma

Auto-generated profile, based on publicly available information

Samuli Saarelma

Culham Centre for Fusion Energy

Research Focus & Metrics

Academic Career Length

12Years (2015-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
23 September 2021 in Nuclear Fusion
Verified
Journal Article
Closed access
AMA. Marinoni
A. Marinoni
MAM.E. Austin
M.E. Austin
AHA.W. Hyatt
A.W. Hyatt
SSS. Saarelma
S. Saarelma
FSF. Scotti
F. Scotti
TTthe DIII-D Team
the DIII-D Team

22 June 2022 in Nuclear Fusion
Verified
Journal Article
Open access
BCB. Chapman-Oplopoiou
B. Chapman-Oplopoiou
DHD.R. Hatch
D.R. Hatch
AFA.R. Field
A.R. Field
LFLorenzo Frassineti
Lorenzo Frassineti
JHJ.C. Hillesheim
J.C. Hillesheim
JWJ. Walker
J. Walker
We present the results of GENE gyrokinetic calculations based on a series of JET–ITER-like-wall (ILW) type I ELMy H-mode discharges operating with similar experimental inputs but at different levels of power and gas fuelling. We show that turbulence due to electron-temperature-gradient (ETGs) modes produces a significant amount of heat flux in four JET–ILW discharges, and, when combined with neoclassical simulations, is able to reproduce the experimental heat flux for the two low gas pulses. The simulations plausibly reproduce the high-gas heat fluxes as well, although power balance analysis is complicated by short ELM cycles. By independently varying the normalised temperature gradients ( ω T e ) and normalised density gradients ( ω n e ) around their experimental values, we demonstrate that it is the ratio of these two quantities η e = ω T e / ω n e that determines the location of the peak in the ETG growth rate and heat flux spectra. The heat flux increases rapidly as η e increases above the experimental point, suggesting that ETGs limit the temperature gradient in these pulses. When quantities are normalised using the minor radius, only increases in ω T e produce appreciable increases in the ETG growth rates, as well as the largest increases in turbulent heat flux which follow scalings similar to that of critical balance theory. However, when the heat flux is normalised to the electron gyro-Bohm heat flux using the temperature gradient scale length L T e , it follows a linear trend in correspondence with previous work by different authors.

8 September 2021 in Plasma Physics and Controlled Fusion
Verified
Journal Article
Closed access
SSS Saarelma
S Saarelma
MAM E Austin
M E Austin
MKM Knolker
M Knolker
AMA Marinoni
A Marinoni
CPC Paz-Soldan
C Paz-Soldan
PSP B Snyder
P B Snyder
Infinite toroidal mode number ( n = ∞) ballooning mode analysis of negative triangularity discharges on DIII–D shows that the access to 2 nd stability becomes strongly restricted when the top triangularity decreases even modestly from −0.18 to −0.36. This is observed in experiment to coincide with the suppression of the L–H-transition. Further theoretical analysis with ballooning mode limited pedestals shows that the threshold for opening the 2 nd stability access rises from a pedestal temperature of 0.3–1 keV when the top triangularity is decreased from −0.18 to −0.36 indicating that to access the 2 nd stability with the more negative triangular shape would require unrealistically high pedestal temperature. The pedestal predicted by the EPED code agrees with the experimental H-mode profile for the negative triangularity case but in contrast to positive triangular shapes the prediction shows no increase in pedestal height with increasing core pressure when triangularity is negative. This work provides a first model to predict when negative triangularity plasmas can be expected to access the H-mode.

12 October 2023 in Nuclear Fusion
Verified
Journal Article
Open access
JHJ. Hobirk
J. Hobirk
CCC.D. Challis
C.D. Challis
AKA. Kappatou
A. Kappatou
ELE. Lerche
E. Lerche
DKD. Keeling
D. Keeling
MZM. Zerbini
M. Zerbini
The JET hybrid scenario has been developed from low plasma current carbon wall discharges to the record-breaking Deuterium-Tritium plasmas obtained in 2021 with the ITER-like Be/W wall. The development started in pure Deuterium with refinement of the plasma current, and toroidal magnetic field choices and succeeded in solving the heat load challenges arising from 37 MW of injected power in the ITER like wall environment, keeping the radiation in the edge and core controlled, avoiding MHD instabilities and reaching high neutron rates. The Deuterium hybrid plasmas have been re-run in Tritium and methods have been found to keep the radiation controlled but not at high fusion performance probably due to time constraints. For the first time this scenario has been run in Deuterium-Tritium (50:50). These plasmas were re-optimised to have a radiation-stable H-mode entry phase, good impurity control through edge Ti gradient screening and optimised performance with fusion power exceeding 10 MW for longer than three alpha particle slow down times, 8.3 MW averaged over 5 s and fusion energy of 45.8 MJ.

15 November 2017 in Plasma Physics and Controlled Fusion
Verified
Journal Article
Closed access
PDF file
SSS Saarelma
S Saarelma
CCC D Challis
C D Challis
LGL Garzotti
L Garzotti
LFL Frassinetti
L Frassinetti
CMC F Maggi
C F Maggi
JCJet Contributors
Jet Contributors
A pedestal prediction model Europed is built on the existing EPED1 model by coupling it with core transport simulation using a Bohm-gyroBohm transport model to self-consistently predict JET-ILW power scan for hybrid plasmas that display weaker power degradation than the IPB98( y , 2) scaling of the energy confinement time. The weak power degradation is reproduced in the coupled core-pedestal simulation. The coupled core-pedestal model is further tested for a 3.0 MA plasma with the highest stored energy achieved in JET-ILW so far, giving a prediction of the stored plasma energy within the error margins of the measured experimental value. A pedestal density prediction model based on the neutral penetration is tested on a JET-ILW database giving a prediction with an average error of 17% from the experimental data when a parameter taking into account the fuelling rate is added into the model. However the model fails to reproduce the power dependence of the pedestal density implying missing transport physics in the model. The future JET-ILW deuterium campaign with increased heating power is predicted to reach plasma energy of 11 MJ, which would correspond to 11–13 MW of fusion power in equivalent deuterium–tritium plasma but with isotope effects on pedestal stability and core transport ignored.

9 August 2022 in Nuclear Fusion
Verified
Journal Article
Closed access
PDF file
ANAndrew Oakleigh Nelson
Andrew Oakleigh Nelson
CPCarlos Paz-Soldan
Carlos Paz-Soldan
SSSamuli Saarelma
Samuli Saarelma
Instability to high toroidal mode number (n) ballooning modes has been proposed as the primary gradient-limiting mechanism for tokamak equilibria with negative triangularity (NT) (δ) shaping, preventing access to strong H-mode regimes when δ is sufficiently negative. To understand how this mechanism extrapolates to reactor conditions, we model the infinite-n ballooning stability as a function of internal profiles and equilibrium shape using a combination of the CHEASE and BALOO codes. While the critical δ required for avoiding 2nd stability to high-n modes is observed to depend in a complicated way on various shaping parameters, including the equilibrium inverse aspect ratio, elongation and squareness, equilibria with NT are robustly prohibited from accessing the 2nd stability region, offering the prediction that NT reactors should maintain L-mode-like operation. In order to access high-n 2nd stability, the local shear over the entire bad curvature region must be sufficiently negative to overcome curvature destabilization on the low field side. Scalings of the ballooning-limited pedestal height are provided as a function of plasma parameters to aid future scenario design.