Poljoprivredni fakultet Institut za poljoprivrednu tehniku Naučni časopis Faculty of Agriculture Institute of Agricultural Engineering Poljoprivredni fakutet Departman za poljoprivrednu tehniku POLJOPRIVREDNA TEHNIKA University of Belgrade Univerzitet u Novom Sadu 21000 Novi Sad Republika Srbija
Auto-generated profile, based on publicly available information
Ondrej Ponjičan
Poljoprivredni fakultet Institut za poljoprivrednu tehniku Naučni časopis Faculty of Agriculture Institute of Agricultural Engineering Poljoprivredni fakutet Departman za poljoprivrednu tehniku POLJOPRIVREDNA TEHNIKA University of Belgrade Univerzitet u Novom Sadu 21000 Novi Sad Republika Srbija
This study aimed to determine the effects of osmotic dehydration on the kinetics of hot air drying of apricot halves under conditions that were similar to the industrial ones. The osmotic process was performed in a sucrose solution at 40 and 60 °C and concentrations of 50% and 65%. As expected increased temperatures and concentrations of the solution resulted in increased water loss, solid gain and shrinkage. The kinetics of osmotic dehydration were well described by the Peleg model. The effective diffusivity of water 5.50–7.387 × 10−9 m2/s and solute 8.315 × 10−10–1.113 × 10−9 m2/s was calculated for osmotic dehydration. Hot air drying was carried out at 40, 50, and 60 °C with air flow velocities of 1.0 m/s and 1.5 m/s. The drying time shortened with higher temperature and air velocity. The calculated effective diffusion of water was from 3.002 × 10−10 m2/s to 1.970 × 10−9 m2/s. The activation energy was sensitive to selected air temperatures, so greater air velocity resulted in greater activation energy: 46.379–51.514 kJ/mol, and with the osmotic pretreatment, it decreased to 35.216–46.469 kJ/mol. Osmotic dehydration reduced the effective diffusivity of water during the hot air drying process. It also resulted in smaller shrinkage of apricot halves in the hot air drying process.
19 December 2011 in African Journal of Agricultural Research
The physical and mechanical properties of pea, bean, spinach and radish seeds, both processed and packaged for sale, were examined under laboratory conditions. The experiment was conducted in order to determine the initial parameters necessary for adjusting the harvester mode so as to reduce the seed damage and losses. Therefore, the results obtained are of immense importance to the selection of appropriate feeds, i.e. the metering mechanism, and setting the operating mode. The following basic physical properties of seeds were measured: dimensions, shape, moisture content, mass of 1000 seeds, the bulk density and the angle of static friction. Mechanical properties were determined by measuring the slope of the load depending on the strain. The slope of the curve load/deflection was determined in three intervals. The first slope of the curve was measured in the area of elastic deformation, the second slope in the area of elastic/plastic deformation, and the third for the rupture point. On the basis of the mean value of the cross-section, the destruction stress and the secant modulus of elasticity were calculated at the point of destruction.
1 January 2017 in Savremena poljoprivredna tehnika
In the Republic of Serbia, about 3% of the utilised areas are irrigated, with an extremely high and unfavourable structure of groundwater use of 52%. Groundwater is a limited resource. It is estimated that agriculture bakes about 70% of fresh water, and it shows the strong dependence agriculture on the water availability. Climate change would exert additional pressure on water resources and the water consumption would increase 70-90% by 2050. In process of optimal irrigation method selection, potential environmental pollution factors due to irrigation should be considered. In order to achieve the necessary efficiency of the irrigation system it needs to be based on the principles of precision agriculture using precise irrigation (PI) and designation of irrigation schedule (IS). Parameters such as Water Use Efficiency (WUE) and Water Productivity (WP) are commonly used to assess irrigation methods.
1 January 2019 in Journal on Processing and Energy in Agriculture
The hot air convective drying of blueberries (Vaccinium corymbosum) in a thin layer was performed using a laboratory-scale dryer. The experiments were carried out at drying air temperatures of 60, 70 and 80 o C, and drying air velocities of 0.5 and 1.5 m/s. At higher values of the drying air temperature and the drying air velocity, less time was required for the convective drying of blueberries, i.e. the drying time of blueberries decreased with increasing drying air temperatures and velocities. The experimental data obtained during the drying process were fitted to ten different mathematical models. The Midilli et al. model was found to be the most appropriate model for explaining the drying behavior of blueberries during convective drying. Effective moisture diffusion coefficients were calculated using the Fick's diffusion model, ranging from 9.66 x 10-12 m2 /s to 9.67 x 10-11 m2 /s. These values were found to increase proportionally with the increase in drying air temperatures and velocities. The lowest total color change and shrinkage of dried blueberries were recorded during freeze drying. A water activity less than 0.6 was measured at a blueberry moisture content of 0.235 kgw/kgd.m, a drying air temperature of 26 o C and a relative air humidity of 60 %.
The paper presents kinetics of osmotic dehydration of plums in relation to the treatment time and concentration of sucrose solution. The main aim of the study was polyoptimisation of the preservation process, namely selection of optimal parameters of osmotic dehydration processes including changes in selected quality indicators. Defining of optimal conditions of the entire course of preservation may influence limitation of consumption of preserving substances (osmotic substances) and reduction of the energy demand. Based on the research which was carried out, it was found that parameters of osmotic dehydration had a significant impact on mass transfer coefficients and physico-chemical indicators of fruit - along with the increase of concentration of osmotic solution and extension of the time of the process, the increase of the investigated sizes was observed. In the second part of the paper, optimization of the fruit preservation process was performed. The idea of the objective function consisted in minimization of the difference between the expected values of criteria and the values obtained from the experimental results. For the defined scalar optimization criterion an explicit relation between quality and cost of the product was showed.