1 January 2025 in ECS Journal of Solid State Science and Technology
After a short description of the evolution of metal-oxide-semiconductor device architectures and the corresponding requirements on epitaxial growth processes, the manuscript describes the material properties of complicated Si/SiGe multi-layer stacks used for complementary field effect transistor (CFET) devices. They contain two different Ge concentrations and have been grown using conventional process gases. A relatively high growth temperature is used to obtain acceptable Si and SiGe growth rates. Still island growth has been suppressed for Ge concentrations up to 40%. Excellent structural and optical material properties of the Si/SiGe multi-layer stack will be reported, with up to 3 + 3 Si channels in the top and bottom part of the stack, respectively. The absence/presence of lattice defects has also been verified by room-temperature photoluminescence measurements. Photoluminescence measurements at low temperatures are used to study band-to-band luminescence from individual sub-layers and to illustrate the optical material quality of the CFET stack.
1 December 1998 in Semiconductor Science and Technology
The effect of using an indium flux during the MBE growth of GaN layers was investigated. The properties of these layers were studied using electron probe microanalysis, secondary ion mass spectroscopy, photoluminescence and cathodoluminescence. The optical properties of the GaN layers are shown to improve as compared with undoped GaN layers grown under nominally the same conditions but without an additional indium flux.
1 September 2024 in Journal of Vacuum Science & Technology A
OrbiSIMS is a secondary ion mass spectrometry method with dual mass analyzers: a time-of-flight (ToF) mass spectrometer for high-speed imaging and an Orbitrap™ for high mass resolving power and mass accuracy. Originally developed for biological imaging, there is now growing interest in the application to semiconductor materials to resolve peak interferences that obfuscate analysis in traditional SIMS depth profiling experiments. We use a new method to calibrate the Orbitrap intensity scale to true counts, which allows comparison of the useful yield and duty cycle with a magnetic sector instrument and a time-of-flight instrument using an Sb implant in the silicon sample. The useful yield of the Orbitrap and magnetic sector instruments (for one detected peak) are similar. However, since the magnetic sector instrument has serial mass detection, its useful yield reduces as more peaks are analyzed. While the ToF instrument has parallel detection, it has a low duty cycle and the useful yield is two orders of magnitude lower for 1000 eV Cs+ sputtering. The depth resolution was also compared from the measurement of the downslope from depth profiles of an Sb delta multilayer. For 1000 eV Cs+ sputtering, the downslopes are 3.9, 2.3, and 2.7 nm/decade for Orbitrap, magnetic sector, and ToF instruments, respectively. Ion trajectory simulation shows that the poorer depth resolution of the OrbiSIMS is in part due to ion beam distortion at low energy.
1 April 1996 in Semiconductor Science and Technology
We have studied the incorporation of Be and Si in GaN grown using molecular beam epitaxy (MBE). From secondary-ion mass spectroscopy (SIMS) measurements, Be was found to have an enhanced diffusion rate at high concentration similar to the behaviour observed previously in GaAs. On the other hand, Si behaves as a conventional n-type dopant with no evidence from SIMS for either segregation or diffusion out of the layer. For Be-incorporated material we report new lines in the PL spectrum for both wurtzite and zinc blende polytypes, and we suggest that Be may be a suitable dopant for the zinc blende material.
4 August 2025 in Journal of Applied Physics
Epitaxially grown Si/Si1−xGex multi-stacks with ≥100 bilayers (≥200 sublayers) are being considered for three dimensionally vertically stacked dynamic random access memory devices. Because of the lattice mismatch between Si1−xGex and Si, the high total layer thickness, and the need for sharp interfaces, it is challenging to develop a low cost epitaxial growth process. This work describes the material characteristics of multi-stacks containing up to 120 pairs (241 sub-layers) of {65 nm Si/10 nm Si0.8Ge0.2} epitaxially grown on 300 mm Si wafers, with fully strained layer stacks at the inner part of the wafers. This Ge concentration allows a high etching selectivity during selective lateral Si0.8Ge0.2 removal later in the device fabrication. However, misfit dislocations are formed near the rim of the wafer, as the wafer edge lowers the energy barrier to form misfit locations. The drive for layer relaxation is reduced by reducing the lattice mismatch between Si and Si1−xGex. This can be done either by adding carbon into the Si1−xGex or by reducing the Ge concentration in the Si1−xGex layers. It will also be discussed how deposition on the reactor quartz tube might affect the temperature of the growing surface, leading to drifts in both layer-to-layer and within-wafer uniformities, and how these issues can be mitigated.
18 September 2023 in Applied Physics Letters
Rare earth (RE):transition metal (TM) ferrimagnetic alloys continue to attract significant attention for spintronics. This work focuses on the elemental distribution of RE and TM elements throughout the thickness of nominally uniform films and the resulting spatial variations of the magnetization within these layers. Samples of CoFe alloyed with Gd were studied using secondary ion mass spectroscopy, polarized neutron reflectometry, and x-ray resonant magnetic reflectivity. The samples were grown by magnetron co-sputtering to control the RE:TM alloy ratio of the ferrimagnetic layer, which was combined with W and Pt layers as either under or over-layers to create sample structures such as W/Gdx(Co70Fe30)100−x/Pt, where x = 0, 8, and 23 at. %. Results show that uniformly deposited thin-films have a significant variation in the distribution of the TM and RE through the film thickness, and this leads to a spatial distribution in the net magnetization profile and a non-uniform Gd magnetization profile within the layer. These findings have implications for the application RE:TM alloys in spintronics as they may impact the perpendicular magnetic anisotropy, the ferrimagnetic compensation temperature, and interfacial spin transport.