24 November 2023 in International Journal of Fatigue
7 April 2022 in Materialwissenschaft und Werkstofftechnik
The combined isotropic‐kinematic hardening model enables the description of the cyclic transient elastic‐plastic material behaviour of steel. However, the determination of the material model parameters and understanding of their influence on the material response can be a challenging task. This study deals with the individual steps of the material model calibration for the simulation of thin electrical steel sheets under cyclic loading. Specific recommendations are made for the determination of kinematic and isotropic hardening material parameters. In particular, the isotropic hardening evolution is described by Voce's exponential law and a simple multilinear approach. Based on the multilinear approach, which allows for different slopes in the evolution of the yield surface size, an alternative calibration of the isotropic hardening component is proposed. As a result, the presence of the yield plateau in the first half cycle can be accurately captured, while convergence issues in the material model definition for numerical simulations can be avoided. The comparison of simulated load cycles with experimental cyclic tests shows a good agreement, which indicates the suitability of the proposed material model calibration for electrical steel.
26 April 2023 in Materialwissenschaft und Werkstofftechnik
The shear cutting of electrical steel sheets has a significant influence on the magnetic and mechanical material properties. Due to plastic deformation and strain hardening in the area of the punched edge, the electrical steel sheets exhibit a characteristic hardness profile. This study deals with the modelling of the resulting hardness profile by means of finite‐element simulations. Elastic‐plastic material properties are obtained from spherical nanoindentation testing as a function of the local hardness. In particular, representative stress‐strain values are determined by applying Tabor's concept of indentation stress‐strain curves. The choice of the appropriate stress‐ and strain‐constraint factors is discussed with respect to the nanoindentation test setup used. Following this, the representative stress‐strain values are analytically described to determine true stress‐strain curves for the local assignment of different material models depending on the hardness. The implementation of the modelling approach in a finite‐element simulation is presented for a punched electrical steel sheet specimen under monotonic loading. The simulation results are basically in good agreement with experimental data and confirm the expected influence on the mechanical material behaviour due to the shear cutting process.
28 April 2025 in Materialwissenschaft und Werkstofftechnik
The fatigue behavior of a fully processed, non‐oriented electrical steel sheet is investigated for different shear cutting parameters. Therefore, three cutting clearances (15 μm, 35 μm and 50 μm) in combination with two different punching tool wear states (sharp and worn) are compared regarding their mechanical properties. For this purpose, surface measurements, nanoindentation tests and stress‐controlled fatigue tests with a positive load ratio are performed for all six parameter sets. During shear cutting the material gets locally strain‐hardened and a deformed surface with micro‐notches is created. Compared to a polished reference condition, the fatigue strength of the shear‐cut sheets is severely deteriorated. However, the intensity of deterioration varies depending on the shear cutting parameters. For small cutting clearances, the highest fatigue life is observed for a sharp cutting tool. In contrast, for medium and high cutting clearances, samples that are cut with a worn tool achieve higher fatigue lives. Surface characteristics in the fracture zone, which act as a failure‐critical crack location, are considered as the main influencing factor.