27 September 2021 in Proceedings of the Voronezh State University of Engineering Technologies
In extrusion 3D printing, the rheological properties of food are critical to achieving quality printing. The aim of this study is to investigate potential correlations between the printability of food pastes and rheological characteristics. Potato and tomato puree were used as a model system. The rheological properties of mashed potatoes with the addition of potato starch and their behavior during 3D printing have been investigated. A correlation has been established between the formulation and manufacturability in 3D printing. Potato mass without starch had a low yield point, which affected the deformation and subsidence of the mass later. At the same time, the addition of 2% starch showed excellent extrudability and printability, that is, the ability to flow. Under these conditions, the printed objects had a smooth shape, good resolution, and could withstand shape over time. The object with the addition of 4% starch represented good shape retention but poor extrudability due to its high consistency index and toughness. The results obtained using tomato puree showed a linear correlation between ingredient flow stress, zero shear viscosity and corresponding print stability. The extrusion pressure required to extrude tomato paste increases linearly with increasing flow voltage. Modules of viscosity, elasticity, and zero shear rate turned out to be not linearly correlated with the extrusion force, which can be explained by the fact that these parameters reflect the rheological properties of the non-deforming state of the material, in contrast to the flow stresses.
2 October 2024 in Food Processing: Techniques and Technology
Consumer properties of chocolate depend largely on the quality of cocoa butter, which affects the technological processes of chocolate production. This article introduces a new method of calorimetry-based mathematical modeling applied to polymorphic forms of cocoa butter. The authors studied various samples of cocoa butter from different manufacturers using the method of differential scanning calorimetry. The results of experimental studies were processed as a Gaussian distribution. The new method of cocoa butter quality assessment relied on experimental data processed as distribution dependencies of polymorphic cocoa butter forms. The latter were identified as follows: 1) a low-melting form (10–18 °C); 2) polymorphic form α (17–24 °C); 3) metastable form β' (27–29 °C); 4) polymorphic form β (28–30 °C). The authors also calculated the proportion of polymorphic forms of cocoa butter according to their melting point. The method facilitated the quality assessment of cocoa butter, which renders good prospects for the chocolate industry.