22 January 2021 in IEEE Access
The paper reports the results of the test and modelling activities carried out on large commercial supercapacitor cells at high current. Four commercials cells, with rated capacitance of 3000 F and rated voltage of 2.7 V, are considered. All cells are submitted to consecutive charge/discharge cycles at constant current. A test current in the range 80–130 A is used, which is comparable with the maximum operating current (up to 150 A) that the cells can reach in practical operations. A circuit model of the cells, able to reproduce the most relevant dynamic behavior, with a good compromise between accuracy, simplicity and robustness of the model’s parameters, is also developed and validated against the experimental data. It is shown that all the investigated commercial cells are characterized by similar phenomena and comply with the same circuit model. Moreover, it is shown that the circuit parameters of the cells are in the same range and are weakly dependent on the test current. The obtained circuit parameters are accurately reported for all the cells and made fully accessible to users.
9 August 2018 in IEEE Transactions on Plasma Science
In many relevant cases requiring a net energy comparable with that of a household appliance, the power supplies (PSs) and the electrical systems must be oversized to sustain short peak demands. The same equivalent energy could be achieved by storing and distributing the power over the time. These considerations lead to a new PS concept based on the exploitation of the energy stored between the actual operations. The new compact ( $60\,\,\text {cm} \times 120\,\,\text {cm} \times 190$ cm) PS is able to generate arbitrary currents up to 2 kA by an integrated energy storage system based on supercapacitors. The delivered output power (approximately 200 kW) is obtained from a very low and tunable input power (<1 kW). Furthermore, a portion of the injected power can be recovered in the storage system. Even though the system was designed for a specific project (the PROTO-SPHERA spherical tokamak), the presented approach can be applied to general-purpose PSs, and there are encouraging prospects to extend it to large facilities with higher currents and voltages.