B. A. Szost

B. A. Szost

Auto-generated profile, based on publicly available information

B. A. Szost

European Space Agency, ESTEC, Keplerlaan 1, PO Box 299, NL-2200 AG Noordwijk, The Netherlands

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 September 2016 in Materials Science and Technology
Verified
Journal Article
Open access
FMF. Martina
F. Martina
MRMatthew Roy
Matthew Roy
BSB. A. Szost
B. A. Szost
STS. Terzi
S. Terzi
PCP. A. Colegrove
P. A. Colegrove
MHM. Hofmann
M. Hofmann
Wire + arc additive manufacturing components contain significant residual stresses, which manifest in distortion. High-pressure rolling was applied to each layer of a linear Ti–6Al–4V wire + arc additive manufacturing component in between deposition passes. In rolled specimens, out-of-plane distortion was more than halved; a change in the deposits' geometry due to plastic deformation was observed and process repeatability was increased. The Contour method of residual stresses measurements showed that although the specimens still exhibited tensile stresses (up to 500 MPa), their magnitude was reduced by 60%, particularly at the interface between deposit and substrate. The results were validated with neutron diffraction measurements, which were in good agreement away from the baseplate. This paper is part of a Themed Issue on Measurement, modelling and mitigation of residual stress.