1 December 2013 in Structure and Infrastructure Engineering
The accurate estimation of site-specific lifetime extreme traffic load effects is an important element in the cost-effective assessment of bridges. A common approach is to use statistical distributions derived from weigh-in-motion measurements as the basis for Monte Carlo simulation of traffic loading. However, results are highly sensitive to the assumptions made, not just with regard to vehicle weights but also to axle configurations and gaps between vehicles. This paper presents a comprehensive model for Monte Carlo simulation of bridge loading for free-flowing traffic and shows how the model matches results from measurements on five European highways. The model has been optimised to allow the simulation of many years of traffic and this greatly reduces the variance in calculating estimates for lifetime loading from the model. The approach described here does not remove the uncertainty inherent in estimating lifetime maximum loading from data collected over relatively short time periods.
1 March 2015 in Structural Safety
1 July 2011 in Structural Safety
1 December 2010 in Engineering Structures
1 March 2013 in Journal of Bridge Engineering
This paper presents results based on the analysis of an extensive database of weigh-in-motion (WIM) data collected at five European highway sites in recent years. The data are used as the basis for a Monte Carlo simulation of bridge loading by two-lane traffic, both bidirectional and in the same direction. Long runs of the simulation model are used to calculate characteristic bridge load effects (bending moments and shear forces), and these characteristic values are compared with design values for bridges of different lengths as specified by the Eurocode for bridge traffic loading. Various indicators are tested as possible bases for a bridge aggressiveness index to characterize the traffic measured by the WIM data in terms of its influence on characteristic bridge load effects. WIM measurements can thus be used to determine the aggressiveness of traffic for bridges. The mean maximum weekly gross vehicle weight is proposed as the most effective of the indicators considered and is shown to be well c...
1 March 2010 in Journal of Bridge Engineering
To predict characteristic extreme traffic load effects, simulations are sometimes performed of bridge loading events. To generalize the truck weight data, statistical distributions are fitted to histograms of weight measurements. This paper is based on extensive weight-in-motion measurements from two European sites and shows the sensitivity of the characteristic traffic load effects to the fitting process. A semiparametric fitting procedure is proposed: direct use of the measured histogram where there are sufficient data for this to be reliable and parametric fitting to a statistical distribution in the tail region where there are less data. Calculated characteristic load effects are shown to be highly sensitive to the fit in the tail region of the histogram.