28 July 2006 in Journal of Geophysical Research
25 October 2006 in Geophysical Research Letters
Geophysical signals accompanying the reactivation of a volcano after a period of quiescence must be evaluated as potential precursors to impending eruption. Here we report on the reactivation of the central volcanic complex of Tenerife, Spain, in spring 2004 and present gravity change maps constructed by time‐lapse microgravity measurements taken between May 2004 and July 2005. The gravity changes indicate that the recent reactivation after almost a century of inactivity was accompanied by a sub‐surface mass addition, yet we did not detect widespread surface deformation. We find that the causative source was evolving in space and time and infer fluid migration at depth as the most likely cause for mass increase. Our results demonstrate that, even in the absence of previous baseline data and ground deformation, microgravity measurements early in developing crises provide crucial insight into the dynamic changes beneath a volcano.
22 July 2016 in Nature Communications
Silicic calderas form during explosive volcanic eruptions when magma withdrawal triggers collapse along bounding faults. The nature of specific interactions between magmatism and tectonism in caldera-forming systems is, however, unclear. Regional stress patterns may control the location and geometry of magma reservoirs, which in turn may control the spatial and temporal development of faults. Here we provide new insight into strike-slip volcano-tectonic relations by analysing Bouguer gravity data from Ilopango caldera, El Salvador, which has a long history of catastrophic explosive eruptions. The observed low gravity beneath the caldera is aligned along the principal horizontal stress orientations of the El Salvador Fault Zone. Data inversion shows that the causative low-density structure extends to ca. 6 km depth, which we interpret as a shallow plumbing system comprising a fractured hydrothermal reservoir overlying a magmatic reservoir with "Equation missing" vol% exsolved vapour. Fault-controlled localization of magma constrains potential vent locations for future eruptions.
1 December 2006 in Geophysical Journal International
We present an evaluation of residual vertical gravity–height change gradients obtained from gravimetric and elevation data between 1982 and 2000 at the Campi Flegrei caldera (CFc) in Italy. Spatial and temporal variations in the gradients are indicative of multiple causative sources during unrest, in particular for ground subsidence from 1988 onwards. Supported by results obtained from time-series inversion for the period 1988–2000 using a random search approach of a purely elastic earth model and a genetic algorithm accounting for elastic-gravitational effects, we propose a centre of dilatation undergoing predominantly pressure changes yet negligible mass changes as the dominant cause for caldera deflation. Mass fluctuations in randomly active secondary sources along the periphery of the CFc can be best explained by dynamic changes along the caldera boundary (ring) faults.
22 May 2014 in Journal of Geophysical Research: Solid Earth
Using ground deformation data from Soufrière Hills volcano (SHV), we present results from numerical modeling of the temperature‐ and time‐dependent stress evolution in a mechanically heterogeneous crust prior to reservoir failure and renewed eruptive activity. The best fit models do not allow us to discriminate between a magmatic plumbing system consisting of either a single vertically elongated reservoir or a series of stacked reservoirs. A prolate reservoir geometry with volumes between 50 and 100 km3, reservoir pressure changes between 4 and 7 MPa, and reservoir volume changes between 0.03 and 0.04 km3 with magma compressibility between 4 × 10−11 and 1 × 10−9 Pa−1 provide plausible thermomechanical model parameters to explain the deformation time series; around an order of magnitude less overpressure than is generally inferred from homogeneous, elastic crustal models. Reservoir failure is predicted to occur at the crest of the reservoir except for reservoirs with highly compressible magma ( Pa) for which subhorizontal sill formation is predicted upon reservoir failure. Introducing a deep‐crustal hot zone modulates the partitioning of strains into the hotter underlying crust and results in a further reduction in overpressure estimates to values of around 1–2 MPa upon reservoir failure. Deduced volume fluxes are consistent with constraints from thermal modeling of active subvolcanic systems and imply dynamic failure of a compressible magma mush column feeding eruptions at SHV. Our interpretation of the results is that the combined thermomechanical effects of a deep‐crustal hot zone and hot encasing rocks around a midcrustal andesitic reservoir fundamentally alter the time‐dependent subsurface stress and strain partitioning upon reservoir priming. These effects substantially influence surface strains recorded by volcano geodetic monitoring.
12 April 2016 in Solid Earth
Ground deformation and gravity changes in restless calderas during periods of unrest can signal an impending eruption and thus must be correctly interpreted for hazard evaluation. It is critical to differentiate variation of geophysical observables related to volume and pressure changes induced by magma migration from shallow hydrothermal activity associated with hot fluids of magmatic origin rising from depth. In this paper we present a numerical model to evaluate the thermo-poroelastic response of the hydrothermal system in a caldera setting by simulating pore pressure and thermal expansion associated with deep injection of hot fluids (water and carbon dioxide). Hydrothermal fluid circulation is simulated using TOUGH2, a multicomponent multiphase simulator of fluid flows in porous media. Changes in pore pressure and temperature are then evaluated and fed into a thermo-poroelastic model (one-way coupling), which is based on a finite-difference numerical method designed for axi-symmetric problems in unbounded domains.Informed by constraints available for the Campi Flegrei caldera (Italy), a series of simulations assess the influence of fluid injection rates and mechanical properties on the hydrothermal system, uplift and gravity. Heterogeneities in hydrological and mechanical properties associated with the presence of ring faults are a key determinant of the fluid flow pattern and consequently the geophysical observables. Peaks (in absolute value) of uplift and gravity change profiles computed at the ground surface are located close to injection points (namely at the centre of the model and fault areas). Temporal evolution of the ground deformation indicates that the contribution of thermal effects to the total uplift is almost negligible with respect to the pore pressure contribution during the first years of the unrest, but increases in time and becomes dominant after a long period of the simulation. After a transient increase over the first years of unrest, gravity changes become negative and decrease monotonically towards a steady-state value. Since the physics of the investigated hydrothermal system is similar to any fluid-filled reservoir, such as oil fields or CO2 reservoirs produced by sequestration, the generic formulation of the model will allow it to be employed in monitoring and interpretation of deformation and gravity data associated with other geophysical hazards that pose a risk to human activity.