2 December 2013 in Applied Physics Letters
The anisotropic effective electron masses in wurtzite GaN are determined by generalized infrared spectroscopic ellipsometry. Nonpolar oriented thin films allow accessing both effective masses, and , by determining the screened plasma frequencies. A n-type doping range up to 1.7 × 1020 cm−3 is investigated. The effective mass ratio is obtained with highest accuracy and is found to be 1.11 independent on electron concentration up to 1.2 × 1020 cm−3. For higher electron concentrations, the conduction band non-parabolicity is mirrored in changes. Absolute values for effective electron masses depend on additional input of carrier concentrations determined by Hall effect measurements. We obtain and for the parabolic range of the GaN conduction band. Our data are indication of a parabolic GaN conduction band up to an energy of approximately 400 meV above the conduction band minimum.
16 February 2009 in Journal of Physics D: Applied Physics
13 July 2017 in Journal of Applied Physics
Semi-insulating GaN is a prerequisite for lateral high frequency and high power electronic devices to isolate the device region from parasitic conductive channels. The commonly used dopants for achieving semi-insulating GaN, Fe, and C cause distinct properties of GaN layers since the Fermi-level is located either above (Fe) or below (C) the midgap position. In this study, precursor-based doping of GaN in metalorganic vapor phase epitaxy is used at otherwise identical growth conditions to control the dopant concentrations in the layer. Using electric force microscopy, we have investigated the contact potentials of Fe- and C-doped samples with respect to a cobalt metal probe tip in dependence of on the dopant concentration. While in Fe-doped samples the sign of the contact potential is constant, a change from positive to negative contact potential values is observed at high carbon concentrations, indicating the shift of the Fermi-level below the midgap position. In vertical transport measurements, C-doped GaN layers with a dopant concentration of 4.6 × 1018 cm−3 exhibit up to 5 orders of magnitude lower dark current at room temperature and significantly lower temperature dependence than Fe-doped samples with a similar dopant concentration. Therefore, precursor-based carbon doping is the superior doping technique to achieve semi-insulating GaN.
6 September 2010 in Physica Status Solidi (b)
3 May 2010 in Physica Status Solidi (b)
11 July 2011 in Applied Physics Letters
We report on the elimination of stacking faults by the insertion of low-temperature AlN interlayers in nearly ( ) and ( ) oriented semi-polar GaN grown by metalorganic vapor phase epitaxy on Si(112) and Si(113), respectively. The elimination of these defects is visualized by cathodoluminescence (CL) as well as scanning transmission electron microscopy (STEM) and STEM-CL. A possible annihilation mechanism is discussed which leads to the conclusion that the elimination mechanism is most likely valid for all layers with ( ) surfaces, enabling heteroepitaxial semi- and non-polar GaN free from stacking faults.