Developing highly efficient, low-density, and mechanically flexible electromagnetic interference (EMI) shielding materials based on conducting polymers has gained significant momentum for suppressing electromagnetic pollution. In our work, we investigated the EMI shielding behavior of uniaxially compressible sponges using the conducting polymer poly(3,4-ethylenedixoythiophene) polystyrene sulfonate (PEDOT:PSS) in the X-band frequency range of 8–12.4 GHz. Two types of PEDOT:PSS sponges, type-I with glycerol and (3-glycidyloxypropyl) trimethoxy silane and type-II containing glycerol and polyethylene glycol, were prepared by freeze-drying method. Both sponges exhibited a rapid decrease in resistance for the initial compressive strain of less than 20%, which stabilized at higher compressive strains. This behavior was likely due to the complex 3D porous structures of the sponges and was linked to the creation of new electrical contacts due to pore collapse under compressive strain. The enhanced electrical conductivity, porous structure, large surface area, and many internal surfaces resulted in exceptional EMI shielding for PEDOT:PSS sponges, achieving shielding values as high as 44 dB and 72 dB, respectively. The EMI shielding in these materials was primarily dominated by the reflection process. This work contributes to developing flexible and high-efficiency EMI shielding materials for flexible electronic applications in the future.
The stability of conducting polymer coatings on metallic substrates is often limited by poor interfacial adhesion, which can lead to delamination and degradation of electrochemical performance. Here, we report low‐impedance printed circuit board (PCB) electrodes based on electrodeposited poly(3,4‐ethylenedioxythiophene) (PEDOT) coatings on gold and electroless nickel–phosphorus (Ni–P) substrates. While PEDOT is widely used to reduce electrode impedance, poor adhesion on metallic substrates, particularly Ni–P, limits coating stability and long‐term performance. To address this limitation, we introduce an interfacial modification strategy based on EDOT‐acid pretreatment, which acts as a molecular adhesion promoter between the metal surface and the electrodeposited PEDOT film. X‐ray photoelectron spectroscopy (XPS) confirms the chemisorption of EDOT‐acid on both Au and Ni–P surfaces through carboxylate bonding and metal–sulfur interactions. Atomic force microscopy force–displacement measurements reveal a substantial increase in local surface adhesion after EDOT‐acid treatment, with adhesion forces increasing by approximately 2.5× on Au and nearly threefold on Ni–P substrates. Electrochemical measurements show that the PEDOT coatings significantly reduce electrode impedance and improve charge storage capacity. The EDOT‐acid pretreatment enables stable PEDOT coatings that remain intact after prolonged sonication, particularly on Ni–P, supporting its use as a cost‐effective alternative to gold.