A stable neural network (NN)-based observer for general multivariable nonlinear systems is presented in this paper. Unlike most previous neural network observers, the proposed observer uses a nonlinear-in-parameters neural network (NLPNN). Therefore, it can be applied to systems with higher degrees of nonlinearity without any a priori knowledge about system dynamics. The learning rule for the neural network is a novel approach based on the modified backpropagation (BP) algorithm. An e-modification term is added to guarantee robustness of the observer. No strictly positive real (SPR) or any other strong assumption is imposed on the proposed approach. The stability of the recurrent neural network observer is shown by Lyapunov's direct method. Simulation results for a flexible-joint manipulator are presented to demonstrate the enhanced performance achieved by utilizing the proposed neural network observer.
9 December 2008 in IEEE Transactions on Neural Networks
This paper presents a robust fault detection and isolation (FDI) scheme for a general class of nonlinear systems using a neural-network-based observer strategy. Both actuator and sensor faults are considered. The nonlinear system considered is subject to both state and sensor uncertainties and disturbances. Two recurrent neural networks are employed to identify general unknown actuator and sensor faults, respectively. The neural network weights are updated according to a modified backpropagation scheme. Unlike many previous methods developed in the literature, our proposed FDI scheme does not rely on availability of full state measurements. The stability of the overall FDI scheme in presence of unknown sensor and actuator faults as well as plant and sensor noise and uncertainties is shown by using the Lyapunov's direct method. The stability analysis developed requires no restrictive assumptions on the system and/or the FDI algorithm. Magnetorquer-type actuators and magnetometer-type sensors that are commonly employed in the attitude control subsystem (ACS) of low-Earth orbit (LEO) satellites for attitude determination and control are considered in our case studies. The effectiveness and capabilities of our proposed fault diagnosis strategy are demonstrated and validated through extensive simulation studies.
25 June 2013 in IEEE Transactions on Control Systems Technology
In this brief a distributed fault detection and isolation (FDI) methodology for a network of heterogeneous multiagent systems with different dynamics and order from one another is proposed. An FDI filter is designed such that the effects of disturbances and control inputs on the residual signals are minimized (for accomplishing the fault detection task) subject to the constraint that the transfer matrix function from the faults to the residuals is equal to a preassigned diagonal transfer matrix (for accomplishing the fault isolation task). Moreover, by utilizing the proposed methodology, isolation of simultaneous occurring faults can also be handled. Sufficient conditions for solvability of the problem are obtained in terms of linear matrix inequality (LMI) feasibility conditions. The extended LMI characterization is then used to reduce the conservativeness of the solution by eliminating the couplings between the Lyapunov matrices and the agents' matrices. Simulation results presented demonstrate the effectiveness and capabilities of our proposed design methodology.
1 November 2017 in International Journal of Electrical Power & Energy Systems
Analytical calculations are effective in preliminary design stages and analysis of electric machines. In this paper, for axial-flux interior permanent-magnet (PM) eddy-current couplers, an analytical model is developed, which is able to deal with the complex machine geometry and take into account material properties such as iron saturation and PM characteristics. The design considerations of the machine are also presented. Moreover, the studied structure shows several advantages in terms of mechanical and magnetic performances over the couplers with surface PMs. The three-dimensional (3-D) finite-element method is employed in the analyses and evaluations. Finally, an experimental prototype is built to validate the model.