28 June 2021 in Nuclear Fusion
The fundamental behavior of the W7-X island divertor under detached conditions, which has been theoretically predicted with the EMC3-Eirene code, is re-examined here under the experimental conditions achieved so far and compared with the first experimental results. Both simulations and experiments cover a range of divertor configurations and plasma parameters, and show the following common trends: (1) with rising impurity radiation, the target heat load decreases ‘uniformly’ over the entire target surface in the sense that both the peak and average heat loads can drop by an order of magnitude. Impurity radiation (mainly from intrinsic carbon) occurs primarily at the plasma edge and the resulting negative impact on the stored energy is less than 10%. (2) When the total radiation exceeds a critical level, the target particle flux (the recycling flux Γrecy) begins to fall and can drop by a factor of 3–5 at high radiation levels without an obvious indication of significant volume recombination. (3) While Γrecy decreases, the divertor neutral pressure continues to build up and reaches a maximum, at which point Γrecy has declined significantly. (4) During detachment, the electron temperature at the last closed flux surface falls in a way that is not quantitatively understandable from parallel classical heat conduction processes. This paper presents a physical explanation of the numerical/experimental results described above. Furthermore, using the EMC3-Eirene code as a diagnostic tool, we are able, apparently for the first time, to provide a full quantitative analysis of each transport channel in the island divertor, aiming to clarify how the island divertor plasma self-regulates to maintain particle, energy, and momentum balance under detached conditions.
30 August 2021 in Nuclear Fusion
Wendelstein 7-X (W7-X), the largest advanced stellarator, is built to demonstrate high power, high performance quasi-continuous operation. Therefore, in the recent campaign, experiments were performed to prepare for long pulse operation, addressing three critical issues: the development of stable detachment, control of the heat and particle exhaust, and the impact of leading edges on plasma performance. The heat and particle exhaust in W7-X is realized with the help of an island divertor, which utilizes large magnetic islands at the plasma boundary. This concept shows very efficient heat flux spreading and favourable scaling with input power. Experiments performed to overload leading edges showed that the island divertor yields good impurity screening. A highlight of the recent campaign was a robust detachment scenario, which allowed reducing power loads even by a factor of ten. At the same time, neutral pressures at the pumping gap entrance yielded the particle removal rate close to the values required for stable density control in steady-state operation.
22 July 2019 in Nuclear Fusion
1 July 1999 in Nuclear Fusion
3 September 2020 in Nuclear Fusion
1 December 2019 in Review of Scientific Instruments
To improve the reliability of the ASDEX pressure gauges in the plasma vessel of the Wendelstein 7-X stellarator, nine of them were equipped with a LaB6 crystal electron emitter for the first time. These crystal cathode pressure gauges were operated during the last campaign in 2018 (operation phase 1.2b) with only 2 A heating current for over 40 h in a magnetic field of about 2.1 T without failure. Owing to this excellent performance, we have decided to equip all pressure gauges with crystal cathodes for the next campaign of Wendelstein 7-X (operation phase 2). We report on a pretest in a superconducting magnet, show a measurement of the neutral pressure in Wendelstein 7-X, and demonstrate the long-term stability of the crystal cathode pressure gauges.