Mahesh Kalita

Mahesh Kalita

Auto-generated profile, based on publicly available information

Mahesh Kalita

Department of Physical Science and Engineering, King Abdullah University of Science and Technology, Thuwal 23955-6900, Saudi Arabia

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
30 October 2019 in Geophysics
Verified
Journal Article
Closed access
OOOleg Ovcharenko
Oleg Ovcharenko
VKVladimir Kazei
Vladimir Kazei
MKMahesh Kalita
Mahesh Kalita
DPDaniel Peter
Daniel Peter
TATariq Alkhalifah
Tariq Alkhalifah
Low-frequency seismic data are crucial for convergence of full-waveform inversion (FWI) to reliable subsurface properties. However, it is challenging to acquire field data with an appropriate signal-to-noise ratio in the low-frequency part of the spectrum. We have extrapolated low-frequency data from the respective higher frequency components of the seismic wavefield by using deep learning. Through wavenumber analysis, we find that extrapolation per shot gather has broader applicability than per-trace extrapolation. We numerically simulate marine seismic surveys for random subsurface models and train a deep convolutional neural network to derive a mapping between high and low frequencies. The trained network is then tested on sections from the BP and SEAM Phase I benchmark models. Our results indicate that we are able to recover 0.25 Hz data from the 2 to 4.5 Hz frequencies. We also determine that the extrapolated data are accurate enough for FWI application.

1 July 2019 in Geophysics
Verified
Journal Article
Closed access
MKMahesh Kalita
Mahesh Kalita
VKVladimir Kazei
Vladimir Kazei
YCYunseok Choi
Yunseok Choi
TATariq Alkhalifah
Tariq Alkhalifah
Full-waveform inversion (FWI) attempts to resolve an ill-posed nonlinear optimization problem to retrieve the unknown subsurface model parameters from seismic data. In general, FWI fails to obtain an adequate representation of models with large high-velocity structures over a wide region, such as salt bodies and the sediments beneath them, in the absence of low frequencies in the recorded seismic signal, due to nonlinearity and nonuniqueness. We alleviate the ill posedness of FWI associated with data sets affected by salt bodies using model regularization. We have split the optimization problem into two parts: First, we minimize the data misfit and the total variation in the model, seeking to achieve an inverted model with sharp interfaces; and second, we minimize sharp velocity drops with depth in the model. Unlike conventional industrial salt flooding, our technique requires minimal human intervention and no information about the top of the salt. Those features are demonstrated on data sets of the BP 2004 and Sigsbee2A models, synthesized from a Ricker wavelet of dominant frequency 5.5 Hz and minimum frequency 3 Hz. We initiate the inversion process with a simple model in which the velocity increases linearly with depth. The model is well-retrieved when the same constant density acoustic code is used to simulate the observed data, which is still one of the most common FWI tests. Moreover, our technique allows us to reconstruct a reasonable depiction of the salt structure from the data synthesized independently with the BP 2004 model with variable density. In the Sigsbee2A model, we manage to even capture some of the fine layering beneath the salt. In addition, we evaluate the versatility of our method on a field data set from the Gulf of Mexico.

1 March 2018 in Geophysics
Verified
Journal Article
Closed access
JOJu-Won Oh
Ju-Won Oh
MKMahesh Kalita
Mahesh Kalita
TATariq Alkhalifah
Tariq Alkhalifah
We have developed an efficient elastic full-waveform inversion (FWI) based on the P-wave excitation amplitude (maximum energy arrival) approximation in the source wavefields. Because, based on the P-wave excitation approximation (ExA), the gradient direction is approximated by the crosscorrelation of source and receiver wavefields at only excitation time, it estimates the gradient direction faster than its conventional counterpart. In addition to this computational speedup, the P-wave ExA automatically ignores SP and SS correlations in the approximated gradient direction. In elastic FWI for ocean bottom cable (OBC) data, the descent direction for the S-wave velocity is often degraded by undesired long-wavelength features from the SS correlation. For this reason, the P-wave excitation approach increases the convergence rate of multiparameter FWI compared with the conventional approach. The modified 2D Marmousi model with OBC acquisition is used to verify the differences between the conventional method and ExA. Finally, the feasibility of the proposed method is demonstrated on a real OBC data from the North Sea.

17 May 2017 in Geophysical Journal International
Verified
Journal Article
Closed access
PDF file
MKMahesh Kalita
Mahesh Kalita
TATariq Alkhalifah
Tariq Alkhalifah
Full waveform inversion (FWI) is an iterative method of data-fitting, aiming at high-resolution recovery of the unknown model parameters. However, its conventional implementation is a cumbersome process, requiring a long computational time and large memory space/disk storage. One of the reasons for this computational limitation is the gradient calculation step. Based on the adjoint state method, it involves the temporal cross-correlation of the forward propagated source wavefield with the backward propagated residuals, in which we usually need to store the source wavefield, or include an extra extrapolation step to propagate the source wavefield from its storage at the boundary. We propose, alternatively, an amplitude excitation gradient calculation based on the excitation imaging condition concept that represents the source wavefield history by a single, specifically the most energetic arrival. An excitation based Born modelling allows us to derive the adjoint operation. In this case, the source wavelet is injected by a cross-correlation step applied to the data residual directly. Representing the source wavefield through the excitation amplitude and time, we reduce the large requirements for both storage and the computational time. We demonstrate the application of this approach on a two-layer model with an anomaly, the Marmousi II model and a marine data set acquired by CGG.

6 June 2016 in Geophysics
Verified
Journal Article
Closed access
MKMahesh Kalita
Mahesh Kalita
TATariq Alkhalifah
Tariq Alkhalifah
Common-image gathers (CIGs) are extensively used in migration velocity analysis. Any defocused events in the subsurface offset domain or equivalently nonflat events in angle-domain CIGs are accounted for revising the migration velocities. However, CIGs from wave-equation methods such as reverse time migration are often expensive to compute, especially in 3D. Using the excitation amplitude imaging condition that simplifies the forward-propagated source wavefield, we have managed to extract extended images for space and time lags in conjunction with prestack reverse time migration. The extended images tend to be cleaner, and the memory cost/disk storage is extensively reduced because we do not need to store the source wavefield. In addition, by avoiding the crosscorrelation calculation, we reduce the computational cost. These features are demonstrated on a linear v(z) model, a two-layer velocity model, and the Marmousi model.

12 June 2017
Verified
Conference Paper
Closed access
PDF file
VKVladimir Kazei
Vladimir Kazei
MKM. Kalita
M. Kalita
TAT. Alkhalifah
T. Alkhalifah