1 July 2016 in Ocean Engineering
This paper focuses on the study of cavitation and underwater noise performance of a biomimetically improved horizontal axis tidal turbine (HATT) with a leading edge design inspired by the tubercles on the pectoral fins of humpback whales. Systematic model tests were recently conducted and details of this test campaign together with the findings are summarised in the paper. Several full-scale tidal turbine application cases were studied to understand the full-scale operating conditions considering the characteristics of varied kinds of tidal energy devices, the varying wave height and the flood/ebb tide. A systematic test regime was then designed and conducted. A set of tidal turbines with different leading-edge profiles was manufactured and tested under different loading and hence cavitation conditions. During the tests, cavitation was observed and underwater noise level was measured in comparison with the cavitation and noise performance of a counterpart HATT without tubercles. The tested turbines displayed two main types of cavitation patterns independent of the tubercles. These were steady tip vortex cavitation and relatively intermittent cloud cavitation with a misty appearance. The leading-edge tubercles triggered the cavitation onset earlier for the tidal turbine but constrained the cavitation region to the trough between tubercles with a lesser extent on the blades. The noise performance was strongly related to the blade cavitation hence it was influenced by the leading-edge tubercles. While the turbine was working under the non-cavitating conditions the total noise level was similar to the background noise level. With the increase of the tip speed ratio the noise level was increased, while increasing blade pitch angle reduced the noise level due to lower blade loading. Cavitation inception and noise diagrams are provided as a database for future studies
1 May 2016 in Ocean Engineering
This paper contributes to the investigations into the feasibility of improving the performance of a marine current turbine using a biomimetic concept inspired from the leading-edge tubercles on the flippers of humpback whales. An experimental test campaign was recently conducted in the Emerson Cavitation Tunnel at Newcastle University and details of this test campaign together with the findings are summarised in the paper A set of tidal turbines with different leading-edge profiles was manufactured and tested to evaluate the hydrodynamic performance. Various tests were conducted at different flow speed and different pitch angle settings of the turbine blades. The results showed that the models with the leading-edge tubercles had higher power coefficients at lower tip speed ratios (TSRs) and at lower pitch angle settings where the turbine blades were working under stall conditions. Therefore, the tubercles can reduce the turbines' cut-in speed to improve the starting performance. The biomimetic concept did not compromise the maximum power coefficient value of the turbine, being comparable to the device without the tubercles, but shifted the distribution of the coefficient over the range of the tip speed ratios tested
1 December 2016 in Renewable Energy
A unique tidal turbine, “Hydro-Spinna”, is introduced. The Hydro-Spinna consists of three cardioidal blades spiralling around a common horizontal shaft. A 500 mm diameter model was manufactured and its performance investigated in the towing tank facility of Newcastle University. The main objective of these experiments was to investigate the hydrodynamic efficiency of Hydro-Spinna with a view to improve the design by collecting data for use in numerical optimization. Considering its flexible operating characteristics the model turbine was tested at different immersion depths and in the half-submerged condition. The power coefficient of the turbine reached a value of almost 0.3 at a tip speed ratio of 2.2 in the fully submerged condition. The turbine had a higher power coefficient in shallow immersion and half submerged condition. The drag coefficient on the whole system decreased with increasing TSR contrary to conventional turbines. The turbine was observed to start rotating at low flow velocities, down to 0.15 m/s. In the study, although the turbine presents a relatively low power coefficient compared to that of competitive turbines, its unique adaptability of immersion depth, including the partially submerged condition, low starting flow velocity and rotational speed offer an interesting prospect for a range of applications
1 August 2020 in Ocean Engineering