Lei Wen

Lei Wen

Auto-generated profile, based on publicly available information

Lei Wen

Key Laboratory of Ministry of Education for Geomechanics and Embankment Engineering, Hohai Univ., Nanjing 210024, China. ORCID:

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 June 2020 in International Journal of Geomechanics
Verified
Journal Article
Closed access
LWLei Wen
Lei Wen
GKGangqiang Kong
Gangqiang Kong
QLQingsong Li
Qingsong Li
ZZZhendong Zhang
Zhendong Zhang
This paper presents full-scale field tests of grouted steel pipe micropile embedded in marine soft clay under compressive and tensile loads. The load-displacement responses, axial forces, tip resistance, and unit skin friction were measured and evaluated. The relationship between skin friction and pile–soil relative displacement in each soil layer is discussed. The bearing capacity of the micropile was improved by the post-grouting technique. After post-grouting, the ultimate skin friction of the soft clay under compression and tension was improved by 48.7% and 30.8%, respectively. The ultimate bearing capacity of the grouted steel pipe micropile under a compression load is approximately twice that under a tension load.

3 June 2020 in Acta Geotechnica
Verified
Journal Article
Closed access
PDF file
GKGangqiang KONG
Gangqiang KONG
LWLei Wen
Lei Wen
HLHanlong Liu
Hanlong Liu
JZJunjie Zheng
Junjie Zheng
Qing YangQing Yang
Qing Yang

1 April 2021 in International Journal of Geomechanics
Verified
Journal Article
Closed access
PDF file
HLHui Li
Hui Li
GKGangqiang KONG
Gangqiang KONG
LWLei Wen
Lei Wen
QYQing Yang
Qing Yang
The thermal effects on the pore-water pressure and strength behavior of marine sediments from the South China Sea were studied by using temperature-controlled triaxial shear tests on reconstituted specimens. The experimental program included consolidation at a temperature of 5°C, undrained and drained heating from 5°C to 50°C, and undrained triaxial shear at 5°C and 50°C. The results indicated that the normalized heating-induced pore-water pressure increased with increasing temperature at the undrained heating stage. The undrained shear strength of the specimens under undrained or drained heating was 14.1% lower or 11.2% higher than that of specimens at 5°C, respectively. The shear-induced pore-water pressure of the specimens under undrained and drained heating was lower than that of the specimens at 5°C by 60.5% and 20.3%, respectively. The increasing temperature caused an increase in the slope of the critical state line (M).

1 April 2021 in Computers and Geotechnics
Verified
Journal Article
Closed access
YZYang Zhou
Yang Zhou
GKGangqiang Kong
Gangqiang Kong
LWLei Wen
Lei Wen
QYQing Yang
Qing Yang