Local chemical short-range ordering (SRO) and spatial fluctuations of planar fault energy are important features of multi-element and metastable complex concentrated alloys (CCAs). Arising from them, dislocations in such alloys are distinctively wavy in both static and migrating conditions; yet, such effects on strength have remained unknown. In this work, molecular dynamics simulations are used to show that the wavy configurations of dislocations and their jumpy motion in a prototypic CCA of NiCoCr are due to the local fluctuations of the energy of SRO shear-faulting that accompanies dislocation motion, with the dislocation getting pinned at sites of hard atomic motifs (HAMs) associated with high local shear-fault energies. Unlike the global averaged shear-fault energy which in general will subdue on successive dislocation passes, the local fluctuations in the fault energy always remain in a CCA, thus offering a strength contribution that is unique in such alloys. Analysis of the magnitude of this form of dislocation resistance shows that this is dominating over contributions due to elastic misfit of alloying elements and is in good agreement with strengths predicted from molecular dynamics simulations and experiments. This work has unfolded the physical basis of strength in CCAs, which is important for the development of these alloys into useful structural materials.
Leaded (Pb) brass components used in water pipeworks are prone to lead leaching following soldering or brazing during installation. Synchrotron radiation X-ray imaging shows that in the initial state of potable-water grade brass samples, Pb exists mainly as isolated or linked-together particles from sub-micron to several microns large. On heating to the usual soldering temperature of ~200 °C, the Pb contents surface rapidly via diffusion pathways involving an interpenetrating Pb–brass structure with orientation relationship (11 $$\bar{1}$$ )α-brass//(220)Pb; [011]α-brass//[ $$\bar{1}$$ 13]Pb. On heating to the usual brazing temperature of 700 °C, the Pb particles melt and expand in volume, with the Pb content forced into the brass lattice preferentially along {101}α-brass planes, forming Pb phase of low sphericity or even large sheets. On immersion in water, the surfaced Pb particles are oxidized to form PbO needles along the normal direction of { $$\bar{2}\bar{2}2$$ }PbO planes, which are then easily washed away to cause Pb leaching.
16 December 2021 in Modelling and Simulation in Materials Science and Engineering
First principles calculations of the energies and relaxation of unreconstructed low-index surfaces, i.e. (001), (011) and (111) surfaces, in NiCoCr and NiFe X ( X = Cu, Co or Cr) equiatomic multi-principal element alloys (MPEAs) are presented. The calculations were conducted for 12-layer slabs represented by special quasi-random supercells using the projector augmented wave method within the generalized gradient approximation. While experimental predictions are unavailable for comparison, the calculated surface energies agree fairly well with those from thermodynamic modeling and a bond-cutting model. In addition, the calculations unveil an important surface structure, namely, that the topmost surface layer is in contraction except for the (001) surface of NiFeCr alloy, the next layer below is in extension, and the bulk spacing is gradually recovered from the subsequent layers down. Additionally, the surface contraction is the most pronounced on the (011) plane, being about 4%–10% relative to the bulk spacings. The results presented here can provide an understanding of surface-controlled phenomena such as corrosion, catalytic activities and fracture properties in these equiatomic MPEAs.