20 March 2019 in IEEE Transactions on Intelligent Vehicles
11 July 2017 in IEEE Transactions on Control Systems Technology
In this paper, a distributed consensus control approach for vehicular platooning systems is proposed. In formalizing the underlying consensus problem, a realistic vehicle dynamics model is considered and a velocity-dependent spacing policy between two consecutive vehicles is realized. As a particular case, the approach allows to consider bidirectional vehicle interaction, which improves the cohesion between vehicles in the platoon. Exponential stability of the platoon dynamics is evaluated, also in the challenging scenario in which a limitation on the velocity of one of the vehicles in the platoon is introduced. The theoretical results are experimentally validated using a three-vehicle platoon consisting of (longitudinally) automated vehicles equipped with wireless intervehicle communication and radar-based sensing.
20 April 2009 in International Journal of Robust and Nonlinear Control
22 October 2010 in Journal of Computational and Nonlinear Dynamics
Rotary drilling systems are known to exhibit torsional stick-slip vibrations, which decrease drilling efficiency and accelerate the wear of drag bits. The mechanisms leading to these torsional vibrations are analyzed using a model that includes both axial and torsional drill string dynamics, which are coupled via a rate-independent bit-rock interaction law. Earlier work following this approach featured a model that lacked two essential aspects, namely, the axial flexibility of the drill string and dissipation due to friction along the bottom hole assembly. In the current paper, axial stiffness and damping are included, and a more realistic model is obtained. In the dynamic analysis of the drill string model, the separation in time scales between the fast axial dynamics and slow torsional dynamics is exploited. Therefore, the fast axial dynamics, which exhibits a stick-slip limit cycle, is analyzed individually. In the dynamic analysis of a drill string model without axial stiffness and damping, an analytical approach can be taken to obtain an approximation of this limit cycle. Due to the additional complexity of the model caused by the inclusion of axial stiffness and damping, this approach cannot be pursued in this work. Therefore, a semi-analytical approach is developed to calculate the exact axial limit cycle. In this approach, parametrized parts of the axial limit cycle are computed analytically. In order to connect these parts, numerical optimization is used to find the unknown parameters. This semi-analytical approach allows for a fast and accurate computation of the axial limit cycles, leading to insight in the phenomena leading to torsional vibrations. The effect of the (fast) axial limit cycle on the (relatively slow) torsional dynamics is driven by the bit-rock interaction and can thus be obtained by averaging the cutting and wearflat forces acting on the drill bit over one axial limit cycle. Using these results, it is shown that the cutting forces generate an apparent velocity-weakening effect in the torsional dynamics, whereas the wearflat forces yield a velocity-strengthening effect. For a realistic bit geometry, the velocity-weakening effect is dominant, leading to the onset of torsional vibrations.
1 August 2007 in International Journal of Control
In this paper convergence properties of piecewise affine (PWA) systems are studied. In general, a system is called convergent if all its solutions converge to some bounded globally asymptotically stable steady-state solution. The notions of exponential, uniform and quadratic convergence are introduced and studied. It is shown that for non-linear systems with discontinuous right-hand sides, quadratic convergence, i.e., convergence with a quadratic Lyapunov function, implies exponential convergence. For PWA systems with continuous right-hand sides it is shown that quadratic convergence is equivalent to the existence of a common quadratic Lyapunov function for the linear parts of the system dynamics in every mode. For discontinuous bimodal PWA systems it is proved that quadratic convergence is equivalent to the requirements that the system has some special structure and that certain passivity-like condition is satisfied. For a general multimodal PWA system these conditions become sufficient for quadratic convergence. An example illustrating the application of the obtained results to a mechanical system with a one-sided restoring characteristic, which is equivalent to an electric circuit with a switching capacitor, is provided. The obtained results facilitate bifurcation analysis of PWA systems excited by periodic inputs, substantiate numerical methods for computing the corresponding periodic responses and help in controller design for PWA systems.