28 November 2021 in ACS Applied Nano Materials
22 August 2022 in Photonics Research
1T-polytype tantalum disulfide ( ), an emerging strongly correlated material, features a narrow bandgap of 0.2 eV, bridging the gap between zero-bandgap graphene and large-bandgap 2D nonlinear optical (NLO) materials. Combined with its intense light absorption, high carrier concentration, and high mobility, shows considerable potential for applications in broadband optoelectronic devices. However, its NLO characteristics and related applications have rarely been explored. Here, nanosheets are prepared by chemical vapor deposition. The ultrafast carrier dynamics in the 400–1100 nm range and broadband NLO performance in the 515–2500 nm range are systematically studied using femtosecond lasers. An obvious saturable absorption phenomenon is observed in the visible to IR range. The nonlinear absorption coefficient is measured to be under 1030 nm, which is larger than that of other typical 2D saturable absorber (SA) materials (graphene, black phosphorus, and ) under similar experimental conditions. Based on these findings, using as a new SA, passively Q-switched laser operations are successfully performed at 1.06, 1.34, and 1.94 μm. The results highlight the promise of for broadband optical modulators and provide a potential candidate material system for mid-IR nonlinear optical applications.
11 July 2023 in Optics Express
Germanene is an analog of graphene, and its independent novel low-bending honeycomb structure gives outstanding advantages such as environmental stability and significant low-frequency optical absorbance. In this paper, the few-layer germanene was successfully prepared by the liquid phase exfoliation method. The saturable absorption characteristics of germanene in the infrared waveband were detected by the open-aperture Z-scan method. With germanene as a saturable absorber, a high-performance passively Q-switched bulk laser was realized at 1.9 µm. The shortest pulse width of 60.5 ns was obtained from continuous-wave pumping, corresponding to a single pulse energy of 6.7 µJ and peak power of 110 W. By utilizing the pulse pumping style with a repletion rate of 10 Hz, the single pulse energy and peak power increased to 45.8 µJ and 328 W, respectively, which exceeded all two-dimensional SA materials reported before. This research manifests that germanene is an excellent SA material for mid-infrared solid-state lasers.
5 February 2024 in Optics Express
In this paper, two-dimensional Graphdiyne and Hexakis-[(trimethylsilyl)ethynyl]benzene nanosheets were prepared using the liquid-phase exfoliation method and were then successfully applied to 1.06 µm passively Q-Switched all-solid-state lasers. The Hexakis-[(trimethylsilyl)ethynyl]benzene was applied for the first time in passively Q-Switched all-solid-state lasers, as we know. For Graphdiyne, the Q-Switched pulse achieved a narrowest pulse width of 415 ns, a maximum repetition frequency of 244.2 kHz, a maximum pulse energy of 133.53 nJ, and peak power of 321.77 mW was obtained. While, the narrowest pulse width, maximum repetition frequency, maximum pulse energy, and peak power for Hexakis-[(trimethylsilyl)ethynyl]benzene are approximately 398.4 ns, 297.1 kHz, 89.61 nJ, and 220.39 mW respectively. The findings demonstrate the promising potential of both candidates as saturable absorbers for signal modulation in solid-state lasers.
21 February 2023 in Laser Physics Letters
A passively Q-switched self-frequency doubling (SFD) green laser based on quasi-continuous diode-pumped and Nd:Ca3TaGa3Si2O14 crystal was developed for the first time with Cr4+:Y3Al5O12 as the saturation absorber. The output wavelength was 533 nm and the maximum average output power was 57 mW, corresponding to single pulse energy, pulse duration, and peak power of 190 μJ, 14.35 ns, and 13.24 kW, respectively. To our knowledge, this is the best result of diode-pumped, pulsed SFD lasers to date. Its compact components and low cost provide a better way to obtain an all-solid-state, miniaturized green laser with high peak power.
16 October 2023 in ACS Applied Nano Materials