Michael Grätzel Center For Mesoscopic Solar Cells Wuhan National Laboratory For Optoelectronics Huazhong University of Science and Technology Wuhan China
Auto-generated profile, based on publicly available information
Anyi Mei
Michael Grätzel Center For Mesoscopic Solar Cells Wuhan National Laboratory For Optoelectronics Huazhong University of Science and Technology Wuhan China
The road ahead for perovskites: The high power conversion efficiencies of small-area perovskite solar cells (PSCs) have driven interest in the development of commercial devices. Rong et al. review recent progress in addressing stability, how to allow mass production, and how to maintain uniformity of large-area films. They note that lifetimes exceeding 10,000 hours under 1 sun (1 kW/m 2 ) illumination have been reported for printable triple mesoscopic PSCs. Science , this issue p. eaat8235
Organometal lead halide perovskites have been widely used as the light harvester for high-performance solar cells. However, typical perovskites of methylammonium lead halides (CH3NH3PbX3, X=Cl, Br, I) are usually sensitive to moisture in ambient air, and thus require an inert atmosphere to process. Here we demonstrate a moisture-induced transformation of perovskite crystals in a triple-layer scaffold of TiO2/ZrO2/Carbon to fabricate printable mesoscopic solar cells. An additive of ammonium chloride (NH4Cl) is employed to assist the crystallization of perovskite, wherein the formation and transition of intermediate CH3NH3X·NH4PbX3(H2O)2 (X=I or Cl) enables high-quality perovskite CH3NH3PbI3 crystals with preferential growth orientation. Correspondingly, the intrinsic perovskite devices based on CH3NH3PbI3 achieve an efficiency of 15.6% and a lifetime of over 130 days in ambient condition with 30% relative humidity. This ambient-processed printable perovskite solar cell provides a promising prospect for mass production, and will promote the development of perovskite-based photovoltaics.
Printable mesoscopic perovskite solar cells (p-MPSCs) do not require the added hole-transport layer needed in traditional p-n junctions but have also exhibited lower power conversion efficiencies of about 19%. We performed device simulation and carrier dynamics analysis to design a p-MPSC with mesoporous layers of semiconducting titanium dioxide, insulating zirconium dioxide, and conducting carbon infiltrated with perovskite that enabled three-dimensional injection of photoexcited electrons into titanium dioxide for collection at a transparent conductor layer. Holes underwent long-distance diffusion toward the carbon back electrode, and this carrier separation reduced recombination at the back contact. Nonradiative recombination at the bulk titanium dioxide/perovskite interface was reduced by ammonium phosphate modification. The resulting p-MPSCs achieved a power conversion efficiency of 22.2% and maintained 97% of their initial efficiency after 750 hours of maximum power point tracking at 55 ± 5°C.