30 April 2012 in Journal of the Atmospheric Sciences
In climate and weather models, the quantitative description of aerosol and cloud processes relies on simplified assumptions. This contributes major uncertainties to the prediction of global and regional climate change. Therefore, models need good parameterizations for heterogeneous ice nucleation by atmospheric aerosols. Here the authors present a new parameterization of immersion freezing on desert dust particles derived from a large number of experiments carried out at the Aerosol Interaction and Dynamics in the Atmosphere (AIDA) cloud chamber facility. The parameterization is valid in the temperature range between −12° and −36°C at or above water saturation and can be used in atmospheric models that include information about the dust surface area. The new parameterization was applied to calculate distribution maps of ice nuclei during a Saharan dust event based on model results from the regional-scale model Consortium for Small-Scale Modelling–Aerosols and Reactive Trace Gases (COSMO-ART). The results were then compared to measurements at the Taunus Observatory on Mount Kleiner Feldberg, Germany, and to three other parameterizations applied to the dust outbreak. The aerosol number concentration and surface area from the COSMO-ART model simulation were taken as input to different parameterizations. Although the surface area from the model agreed well with aerosol measurements during the dust event at Kleiner Feldberg, the ice nuclei (IN) number concentration calculated from the new surface-area-based parameterization was about a factor of 13 less than IN measurements during the same event. Systematic differences of more than a factor of 10 in the IN number concentration were also found among the different parameterizations. Uncertainties in the modeled and measured parameters probably both contribute to this discrepancy and should be addressed in future studies.
21 July 2006 in Atmospheric Chemistry and Physics
The deposition mode ice nucleation efficiency of various dust aerosols was investigated at cirrus cloud temperatures between 196 and 223 K using the aerosol and cloud chamber facility AIDA (Aerosol Interaction and Dynamics in the Atmosphere). Arizona test dust (ATD) as a reference material and two dust samples from the Takla Makan desert in Asia (AD1) and the Sahara (SD2) were used for the experiments at simulated cloud conditions. The dust particle sizes were almost lognormally distributed with mode diameters between 0.3 and 0.5 μm and geometric standard deviations between 1.6 and 1.9. Deposition ice nucleation was most efficient on ATD particles with ice-active particle fractions of about 0.6 and 0.8 at an ice saturation ratio Si<1.15 and temperatures of 223 and 209 K, respectively. No significant change of the ice nucleation efficiency was found in up to three subsequent cycles of ice activation and evaporation with the same ATD aerosol. This indicates that the phenomenon of preactivation does not apply to ATD particles. The desert dust samples SD2 and AD1 showed a significantly lower fraction of active deposition nuclei, about 0.25 at 223 K and Si<1.35. For all samples the ice activated aerosol fraction could be approximated by an exponential equation as function of Si. This indicates that deposition ice nucleation on mineral particles may not be treated in the same stochastic sense as homogeneous freezing. The suggested formulation of ice activation spectra may be used to calculate the formation rate of ice crystals in models, if the number concentration of dust particles is known. More experimental work is needed to quantify the variability of the ice activation spectra as function of the temperature and dust particle properties.
27 April 2009 in Atmospheric Chemistry and Physics
We present results of experiments at the aerosol interactions and dynamics in the atmosphere (AIDA) chamber facility looking at the freezing of water by three different types of mineral particles at temperatures between −12°C and −33°C. The three different dusts are Asia Dust-1 (AD1), Sahara Dust-2 (SD2) and Arizona test Dust (ATD). The dust samples used had particle concentrations of sizes that were log-normally distributed with mode diameters between 0.3 and 0.5 μm and standard deviations, σg, of 1.6–1.9. The results from the freezing experiments are consistent with the singular hypothesis of ice nucleation. The dusts showed different nucleation abilities, with ATD showing a rather sharp increase in ice-active surface site density at temperatures less than −24°C. AD1 was the next most efficient freezing nuclei and showed a more gradual increase in activity than the ATD sample. SD2 was the least active freezing nuclei. We used data taken with particle counting probes to derive the ice-active surface site density forming on the dust as a function of temperature for each of the three samples and polynomial curves are fitted to this data. The curve fits are then used independently within a bin microphysical model to simulate the ice formation rates from the experiments in order to test the validity of parameterising the data with smooth curves. Good agreement is found between the measurements and the model for AD1 and SD2; however, the curve for ATD does not yield results that agree well with the observations. The reason for this is that more experiments between −20 and −24°C are needed to quantify the rather sharp increase in ice-active surface site density on ATD in this temperature regime. The curves presented can be used as parameterisations in atmospheric cloud models where cooling rates of approximately 1°C min−1 or more are present to predict the concentration of ice crystals forming by the condensation-freezing mode of ice nucleation. Finally a polynomial is fitted to all three samples together in order to have a parameterisation describing the average ice-active surface site density vs. temperature for an equal mixture of the three dust samples.
13 September 2012 in Philosophical Transactions of the Royal Society A: Mathematical, Physical and Engineering Sciences
The idea behind the marine cloud-brightening (MCB) geoengineering technique is that seeding marine stratocumulus clouds with copious quantities of roughly monodisperse sub-micrometre sea water particles might significantly enhance the cloud droplet number concentration, and thereby the cloud albedo and possibly longevity. This would produce a cooling, which general circulation model (GCM) computations suggest could—subject to satisfactory resolution of technical and scientific problems identified herein—have the capacity to balance global warming up to the carbon dioxide-doubling point. We describe herein an account of our recent research on a number of critical issues associated with MCB. This involves (i) GCM studies, which are our primary tools for evaluating globally the effectiveness of MCB, and assessing its climate impacts on rainfall amounts and distribution, and also polar sea-ice cover and thickness; (ii) high-resolution modelling of the effects of seeding on marine stratocumulus, which are required to understand the complex array of interacting processes involved in cloud brightening; (iii) microphysical modelling sensitivity studies, examining the influence of seeding amount, seed-particle salt-mass, air-mass characteristics, updraught speed and other parameters on cloud–albedo change; (iv) sea water spray-production techniques; (v) computational fluid dynamics studies of possible large-scale periodicities in Flettner rotors; and (vi) the planning of a three-stage limited-area field research experiment, with the primary objectives of technology testing and determining to what extent, if any, cloud albedo might be enhanced by seeding marine stratocumulus clouds on a spatial scale of around 100×100 km. We stress that there would be no justification for deployment of MCB unless it was clearly established that no significant adverse consequences would result. There would also need to be an international agreement firmly in favour of such action.
21 July 2006 in Atmospheric Chemistry and Physics
The large (7 m×4 m cylinder, 84 m3) AIDA (Aerosol Interactions and Dynamics in the Atmosphere) cloud chamber facility at Forschungszentrum, Karlsruhe, Germany was used to test the ice nucleating ability of two desert dust samples from the Sahara and Asia. Aerosol samples were lognormally distributed with a mode diameter of 0.4(±0.1) μm and geometric standard deviation of ~1.7(±0.2). At temperatures warmer than −40°C droplets were formed before ice crystals formed and there was generally no deposition nucleation observed. At temperatures colder than −40°C both dust samples exhibited dual nucleation events that were observed during the same expansion experiment. The primary nucleation event occurred at ice saturation ratios of 1.1 to 1.3 and is likely to be a deposition nucleation mode. The secondary nucleation event occurred at ice saturation ratios between 1.35 and 1.5. We cannot categorically determine whether this ice nucleation event is via a further deposition mode or a condensation mode, but the presence of some soluble material in the dust samples leads us to favour the latter process. The activated fractions of desert dust ranged from ~5–10% at −20°C to 20–40% at temperatures colder than −40°C. There was no obvious difference between the nucleation behaviour of the two dust samples.
13 January 2011 in Atmospheric Chemistry and Physics
Simultaneous observations of cloud microphysical properties were obtained by in-situ aircraft measurements and ground based Radar/Lidar. Widespread mid-level stratus cloud was present below a temperature inversion (~5 °C magnitude) at 3.6 km altitude. Localised convection (peak updraft 1.5 m s−1) was observed 20 km west of the Radar station. This was associated with convergence at 2.5 km altitude. The convection was unable to penetrate the inversion capping the mid-level stratus. The mid-level stratus cloud was vertically thin (~400 m), horizontally extensive (covering 100 s of km) and persisted for more than 24 h. The cloud consisted of supercooled water droplets and small concentrations of large (~1 mm) stellar/plate like ice which slowly precipitated out. This ice was nucleated at temperatures greater than −12.2 °C and less than −10.0 °C, (cloud top and cloud base temperatures, respectively). No ice seeding from above the cloud layer was observed. This ice was formed by primary nucleation, either through the entrainment of efficient ice nuclei from above/below cloud, or by the slow stochastic activation of immersion freezing ice nuclei contained within the supercooled drops. Above cloud top significant concentrations of sub-micron aerosol were observed and consisted of a mixture of sulphate and carbonaceous material, a potential source of ice nuclei. Particle number concentrations (in the size range 0.1<D<3.0 μm) were measured above and below cloud in concentrations of ~25 cm−3. Ice crystal concentrations in the cloud were constant at around 0.2 L−1. It is estimated that entrainment of aerosol particles into cloud cannot replenish the loss of ice nuclei from the cloud layer via precipitation. Precipitation from the mid-level stratus evaporated before reaching the surface, whereas rates of up to 1 mm h−1 were observed below the convective feature. There is strong evidence for the Hallett-Mossop (HM) process of secondary ice particle production leading to the formation of the precipitation observed. This includes (1) Ice concentrations in the convective feature were more than an order of magnitude greater than the concentration of primary ice in the overlaying stratus, (2) Large concentrations of small pristine columns were observed at the ~−5 °C level together with liquid water droplets and a few rimed ice particles, (3) Columns were larger and increasingly rimed at colder temperatures. Calculated ice splinter production rates are consistent with observed concentrations if the condition that only droplets greater than 24 μm are capable of generating secondary ice splinters is relaxed. This case demonstrates the importance of understanding the formation of ice at slightly supercooled temperatures, as it can lead to secondary ice production and the formation of precipitation in clouds which may not otherwise be considered as significant precipitation sources.